The effect of hole size upon the strength of metallic and polymeric foams

Abstract Tensile and compressive tests have been performed on centre-hole panels, made from three types of metallic foams and two polymeric foams. In compression, the foams fail in a ductile, notch-insensitive manner, in support of a “net section strength” criterion. In tension, a ductile–brittle transition is observed for some of the foams at sufficiently large specimen sizes: for a small hole diameter the net section strength criterion is obeyed, whereas for a large hole a local stress criterion applies and the net section strength is reduced. For a number of the foams, the panel size was not sufficiently large to observe this ductile–brittle switch in behaviour. The predictions of a cohesive zone model are compared with the measured strengths and are found to be in good agreement.