Fabrication of a Large Object by Rapid Prototyping Technics
暂无分享,去创建一个
In order to reduce the lead-time and cost, the technology of rapid prototyping(RP) has been widely used. This paper describes the methodology to fabricate a large object by using the principle of rapid prototyping. By laminating thick and sloping polystyrene foam plates, we can make the large model which has three dimensional, continuous surfaces faster and easier than conventional processes. Estimated error was much smaller than other RP products which have stepped effect. For accuracy improvement and post processing, machined metal plates are added between the thick plates. To keep the continuity of surface and strengthen the model, pilot holes and guide rods are applied. By the methodology described in this paper, a missile body with flush air intake was fabricated.
[1] Syed H. Masood,et al. A volumetric approach to part-build orientations in rapid prototyping , 2001 .
[2] Debasish Dutta,et al. An accurate slicing procedure for layered manufacturing , 1996, Comput. Aided Des..
[3] Peter A. Jacobs,et al. Rapid prototyping with sloping surfaces , 1997 .