The influence of cellulose nanocrystal additions on the performance of cement paste

Abstract The influence of cellulose nanocrystals (CNCs) addition on the performance of cement paste was investigated. Our mechanical tests show an increase in the flexural strength of approximately 30% with only 0.2% volume of CNCs with respect to cement. Isothermal calorimetry (IC) and thermogravimetric analysis (TGA) show that the degree of hydration (DOH) of the cement paste is increased when CNCs are used. The first mechanism that may explain the increased hydration is the steric stabilization, which is the same mechanism by which many water reducing agents (WRAs) disperse the cement particles. Rheological, heat flow rate measurements, and microscopic imaging support this mechanism. A second mechanism also appears to support the increased hydration. The second mechanism that is proposed is referred to as short circuit diffusion. Short circuit diffusion appears to increase cement hydration by increasing the transport of water from outside the hydration product shell (i.e., through the high density CSH) on a cement grain to the unhydrated cement cores. The DOH and flexural strength were measured for cement paste with WRA and CNC to evaluate this hypothesis. Our results indicate that short circuit diffusion is more dominant than steric stabilization.

[1]  Surendra P. Shah,et al.  Carbon Nanotubes Reinforced Concrete , 2009, SP-267: Nanotechnology of Concrete: The Next Big Thing is Small.

[2]  Will Hansen,et al.  Investigation of blended cement hydration by isothermal calorimetry and thermal analysis , 2005 .

[3]  Ashlie Martini,et al.  Cellulose nanomaterials review: structure, properties and nanocomposites. , 2011, Chemical Society reviews.

[4]  E. Nägele.  The Zeta-potential of cement: Part II: Effect of pH-value , 1986 .

[5]  Xiaohua Zhao,et al.  Mechanical behavior and microstructure of cement composites incorporating surface-treated multi-walled carbon nanotubes , 2005 .

[6]  Toyoharu Nawa,et al.  Effect of Chemical Structure on Steric Stabilization of Polycarboxylate-based Superplasticizer , 2006 .

[7]  H. Nakagawa,et al.  Fiber Reinforced Cement Composites , 2014 .

[8]  Nicos Martys,et al.  Parallel-plate Rheometer Calibration Using Oil and Computer Simulation , 2007 .

[9]  Robert Danzer,et al.  The ball on three balls test for strength testing of brittle discs: stress distribution in the disc , 2002 .

[10]  R. Greenwood,et al.  Selection of Suitable Dispersants for Aqueous Suspensions of Zirconia and Titania Powders using Acoustophoresis , 1999 .

[11]  Robert Danzer,et al.  The ball on three balls test for strength testing of brittle discs: Part II: analysis of possible errors in the strength determination , 2004 .

[12]  E. Hasselbrink,et al.  Zeta potential of microfluidic substrates: 1. Theory, experimental techniques, and effects on separations , 2004, Electrophoresis.

[13]  John Bensted,et al.  Structure and Performance of Cements , 2001 .

[14]  E. Nägele.  The zeta-potential of cement , 1987 .

[15]  Gaurav Sant,et al.  Interactions between shrinkage reducing admixtures (SRA) and cement paste's pore solution , 2008 .

[16]  Youssef Habibi,et al.  Highly filled bionanocomposites from functionalized polysaccharide nanocrystals. , 2008, Biomacromolecules.

[17]  Harrie H. M. Wagemans,et al.  Ball-on-ring test revisited , 1989 .

[18]  Hong-lim Lee,et al.  Thermal shock behaviour of alumina ceramics by ball-on-3-ball test , 2002 .

[19]  Xiaohua Zhao,et al.  Pressure-sensitive properties and microstructure of carbon nanotube reinforced cement composites , 2007 .

[20]  Will Hansen,et al.  Volume Relationships for C-S-H Formation Based on Hydration Stoichiometries , 1986 .

[21]  Maria S. Konsta-Gdoutos,et al.  Multi-scale mechanical and fracture characteristics and early-age strain capacity of high performance carbon nanotube/cement nanocomposites , 2010 .