Reverse osmosis desalination modules containing corrugated membranes – Computational study

Abstract Computational fluid dynamics simulation was carried out for three-dimensional desalination modules containing triangular and square ribs attached to the membrane surface. The solution-diffusion membrane transport model was applied along the surface of the corrugated membrane. The membrane flux model which couples the water permeation rate with local salt concentration impose a selective removal of components in the feed channel. The local water flux, salt concentration, wall shear stress, and Sherwood number were monitored over the surface of membranes to determine effects of eddy promoter corrugations on mitigation of concentration polarization and the total water flux. Simulations are conducted using a laminar model for Reynolds number of 100 and k - ω SST turbulence model for Reynolds number of 400 and 1000. Mathematical model and numerical methods employed are validated by comparing predictions against measurements reported earlier. Predicted results agree quantitatively and qualitatively with previous experimental results for membranes with semi-circular cross-sectioned ribs. The results show that corrugated membranes especially triangular chevrons enhance membrane performance profoundly at all flow rates. Water permeation rate is increased, concentration polarization is alleviated, and the potential fouling in the module is reduced by introducing corrugated membranes.

[1]  Ahmad Fauzi Ismail,et al.  A review on RO membrane technology: Developments and challenges , 2015 .

[2]  Dianne E. Wiley,et al.  Numerical study of mass transfer in three-dimensional spacer-filled narrow channels with steady flow , 2007 .

[3]  R. Baker.  Membrane Technology and Applications , 1999 .

[4]  Ephraim M Sparrow,et al.  Reverse osmosis issues relating to pressure drop, mass transfer, turbulence, and unsteadiness , 2014 .

[5]  K. Scott,et al.  Intensified membrane filtration with corrugated membranes , 2000 .

[6]  Ali E. Anqi,et al.  Numerical analysis of hollow fiber membranes for desalination , 2016 .

[7]  Hassan A. Arafat,et al.  Flux stabilization in membrane distillation desalination of seawater and brine using corrugated PVDF membranes , 2015 .

[8]  Ajay K. Mishra,et al.  A critical review of transport through osmotic membranes , 2014 .

[9]  Lianfa Song,et al.  Numerical study on permeate flux enhancement by spacers in a crossflow reverse osmosis channel , 2006 .

[10]  P. R. Neal,et al.  The effect of filament orientation on critical flux and particle deposition in spacer-filled channels , 2003 .

[11]  Viriato Semiao,et al.  Concentration polarisation and flow structure within nanofiltration spiral-wound modules with ladder-type spacers , 2004 .

[12]  Takeshi Matsuura,et al.  A new transport model for pervaporation , 1991 .

[13]  Howland D. T. Jones,et al.  Analysis of micromixers to reduce biofouling on reverse‐osmosis membranes , 2008 .

[14]  Alparslan Oztekin,et al.  Computational study of desalination by reverse osmosis — Three-dimensional analyses , 2016 .

[15]  John Pellegrino,et al.  Influence of sub-micron surface patterns on the deposition of model proteins during active filtration , 2013 .

[16]  Robert H. Davis,et al.  The behavior of suspensions and macromolecular solutions in crossflow microfiltration , 1994 .

[17]  J. Pharoah,et al.  Wall proximity effects on flow over a simple membrane spacer , 2013 .

[18]  Michele Ciofalo,et al.  Investigation of heat transfer in spacer-filled channels by experiments and direct numerical simulations , 2016 .

[19]  P. Sukitpaneenit,et al.  Modified pore-flow model for pervaporation mass transport in PVDF hollow fiber membranes for ethanol–water separation , 2010 .

[20]  R. L. Riley,et al.  Transport properties of cellulose acetate osmotic membranes , 1965 .

[21]  S. G. Yiantsios,et al.  Direct numerical simulation of flow in spacer-filled channels: Effect of spacer geometrical characteristics , 2007 .

[22]  A. Kargol,et al.  Investigation of reverse osmosis on the basis of the Kedem-Katchalsky equations and mechanistic transport equations , 2006 .

[23]  J. G. Wijmans,et al.  The solution-diffusion model: a review , 1995 .

[24]  John Pellegrino,et al.  Fabrication and characterization of a surface-patterned thin film composite membrane , 2014 .

[25]  M. Shakaib,et al.  CFD modeling for flow and mass transfer in spacer-obstructed membrane feed channels , 2009 .

[26]  F. Menter.  Two-equation eddy-viscosity turbulence models for engineering applications , 1994 .

[27]  In Seok Kang,et al.  The effect of turbulence promoters on mass transfer—numerical analysis and flow visualization , 1982 .

[28]  Ali E. Anqi,et al.  Gas Separation Using a Membrane , 2013 .

[29]  George M. Ayoub,et al.  Reverse osmosis technology for water treatment: State of the art review , 2011 .

[30]  Sandeep K. Karode,et al.  Flow visualization through spacer filled channels by computational fluid dynamics I. , 2001 .

[31]  Ali E. Anqi,et al.  Numerical simulation of brackish water desalination by a reverse osmosis membrane , 2015 .

[32]  Howland D. T. Jones,et al.  Systematic analysis of micromixers to minimize biofouling on reverse osmosis membranes. , 2010, Water Research.