Refrigerated cooling air cutting of difficult-to-cut materials

Abstract One approach to enhance machining performance is to apply cutting fluids during cutting process. However, the use of cutting fluids in machining process has caused some problems such as high cost, pollution, and hazards to operator's health. All the problems related to the use of cutting fluids have urged researchers to search for some alternatives to minimize or even avoid the use of cutting fluids in machining operations. Cooling gas cutting is one of these alternatives. This paper investigates the effect of cooling air cutting on tool wear, surface finish and chip shape in finish turning of Inconel 718 nickel-base super alloy and high-speed milling of AISI D2 cold work tool steel. Comparative experiments were conducted under different cooling/lubrication conditions, i.e. dry cutting, minimal quantity lubrication (MQL), cooling air, and cooling air and minimal quantity lubrication (CAMQL). For this research, composite refrigeration method was adopted to develop a new cooling gas equipment which was used to lower the temperature of compressed gas. The significant experimental results were: (i) application of cooing air and CAMQL resulted in drastic reduction in tool wear and surface roughness, and significant improvement in chip shape in finish turning of Inconel 718, (ii) in the high-speed milling of AISI D2, cooling air cutting presented longer tool life and slightly higher surface roughness than dry cutting and MQL. Therefore, it appears that cooling air cutting can provide not only environment friendliness but also great improvement in machinability of difficult-to-cut materials.

[1]  Aldo Attanasio,et al.  Minimal quantity lubrication in turning: Effect on tool wear , 2006 .

[2]  Myung-Chang Kang,et al.  Evaluation of machinability by cutting environments in high-speed milling of difficult-to-cut materials , 2001 .

[3]  John W. Sutherland,et al.  An Experimental Investigation of Air Quality in Wet and Dry Turning , 2000 .

[4]  B. M. Kramer,et al.  On Tool Materials for High Speed Machining , 1987 .

[5]  E. Ezugwu.  Key improvements in the machining of difficult-to-cut aerospace superalloys , 2005 .

[6]  隆夫 山崎,et al.  Ti–6Al–4V合金の冷風切削 , 2003 .

[7]  John W. Sutherland,et al.  Dry Machining and Minimum Quantity Lubrication , 2004 .

[8]  Hossam A. Kishawy,et al.  Effect of coolant strategy on tool performance, chip morphology and surface quality during high-speed machining of A356 aluminum alloy , 2005 .

[9]  Toshiyuki Obikawa,et al.  High-speed grooving with applying MQL , 2006 .

[10]  Yongsheng Su,et al.  An experimental investigation of effects of cooling/lubrication conditions on tool wear in high-speed end milling of Ti-6Al-4V , 2006 .

[11]  A. Kumar,et al.  Effect of Chilled Air on Machining Performance in End Milling , 2003 .

[12]  Tae Jo Ko,et al.  Air–Oil Cooling Method for Turning of Hardened Material , 1999 .

[13]  P. Sreejith,et al.  Dry machining: Machining of the future , 2000 .

[14]  Emmanuel O. Ezugwu,et al.  Finish Machining of Nickel-Base Inconel 718 Alloy with Coated Carbide Tool under Conventional and High-Pressure Coolant Supplies , 2005 .

[15]  Masumi Saka,et al.  Dry and semi-dry machining using finely crystallized diamond coating cutting tools , 2003 .