论文信息 - Partial Discharge Simulation and Analysis Based on Experiment in Underground Distribution Power Cables

Partial Discharge Simulation and Analysis Based on Experiment in Underground Distribution Power Cables

This paper describes the simulation and experiment for partial discharge (PD) pulse propagation in 22.9kV CNCV power cables. To investigate the propagation characteristics of PD, experiments are carried out by injecting the PD pulse in 100m-long 60 mm² CNCV cable in the laboratory. The characteristics of PD are also simulated using EMTP to investigate and analyze PD in the same cable. By comparing the simulation and test results, parameter permittivity is recalculated by considering semiconducting screen in the process of simulation and analysis of PD. After it is proved that simulation results and test results are almost similar in the laboratory, extensive simulations are performed to analyse various PD characteristics such as propagation velocity, attenuation, etc. in 60 mm² and 325 mm² CNCV cables. Authors are confident that results obtained in this paper will be used as important technical materials to detect and investigate PD generated in transmission and distribution power cables.

[1] T. Leibfried,et al. Algorithms for Automated Arrival Time Estimation of Partial Discharge Signals in Power Cables , 2007 .

[2] R. Eriksson,et al. High frequency characteristics of a shielded medium voltage XLPE cable , 2001, 2001 Annual Report Conference on Electrical Insulation and Dielectric Phenomena (Cat. No.01CH37225).

[3] Byoung-Kuk Lee,et al. Advanced LDC Test Bed Using Energy Recovery Technique for HEVs , 2013 .

[4] Jeong-Tae Kim,et al. Analysis of Frequency Response Characteristic Considering Semiconducting Screen in Underground Distribution Cables , 2012 .

[5] François LÉONARD. ON-LINE LOCATION OF PARTIAL DISCHARGES IN AN ELECTRICAL ACCESSORY OF AN UNDERGROUND POWER DISTRIBUTION NETWORK , 2010 .

[6] Ja-Yoon Koo,et al. Pulse Analysis Algorithms for Distinguishing Discharge Sources using Different Types of Sensors , 2008 .

[7] van der Pcjm Peter Wielen,et al. PD detection and localization on HV cable systems lacking integrated sensors , 2007 .

[8] Bjm-n Gustavsen. Panel Session on Data for Modeling Insulated Cables , 2001 .

[9] Gian Carlo Montanari,et al. A new approach to the diagnosis of solid insulation systems based on PD signal inference , 2003 .

[10] Yoichi Hori,et al. Lateral Stability Control of Electric Vehicle Based On Disturbance Accommodating Kalman Filter using the Integration of Single Antenna GPS Receiver and Yaw Rate Sensor , 2013 .