Towards autonomous flight of an unmanned aerial system in plantation forests

This paper presents an Unmanned Aerial System (UAS) for precision forestry applications. The UAS is capable of performing fully autonomous flights under the canopies of an unknown plantation forest by avoiding obstacles without the use of GPS navigation. The navigation framework of this system consists of a velocity estimator and an obstacle avoidance controller. In particular, the velocity estimator estimates raw velocity measurements from the 2D laser scanner using the Point-to-Line Iterative Corresponding Point (PLICP) scan matching algorithm and then fuses the filtered raw velocity measurements with readings from other on-board sensors using an Extended Kalman Filter (EKF). A high-level obstacle avoidance controller is realized by creating a local artificial potential field near the UAS, based on the goal point and nearby obstacles. The performance of the UAS is quantified using indoor and outdoor tests. During the outdoor test, in which the UAS flew autonomously for approximately 28 m within a stand of trees, the minimum distance between the obstacles and UAS was 1.38 m.

[1]  W. Marsden.  I and J , 2012 .

[2]  Marc Pollefeys,et al.  PIXHAWK: A micro aerial vehicle design for autonomous flight using onboard computer vision , 2012, Auton. Robots.

[3]  John P. Fulton,et al.  PRECISION FORESTRY IN THE SOUTHEAST U . S . , 2006 .

[4]  G. Gerhart,et al.  Stereo vision and laser odometry for autonomous helicopters in GPS-denied indoor environments , 2009 .

[5]  Martial Hebert,et al.  Learning monocular reactive UAV control in cluttered natural environments , 2012, 2013 IEEE International Conference on Robotics and Automation.

[6]  Sven Behnke,et al.  PREDICTIVE POTENTIAL FIELD-BASED COLLISION AVOIDANCE FOR MULTICOPTERS , 2013 .

[7]  Tao Wang,et al.  On-board inertial-assisted visual odometer on an embedded system , 2014, 2014 IEEE International Conference on Robotics and Automation (ICRA).

[8]  Sven Behnke,et al.  Obstacle detection and navigation planning for autonomous micro aerial vehicles , 2014, 2014 International Conference on Unmanned Aircraft Systems (ICUAS).

[9]  Sven Behnke,et al.  Towards Autonomous Navigation of an UAV-based Mobile Mapping System , 2014 .

[10]  Sven Behnke,et al.  Omnidirectional Perception for Lightweight MAVs using a Continuously Rotating 3D Laser Omnidirektionale Wahrnehmung für leichte MAVs mittels eines kontinuierlich rotierenden 3D-Laserscanners , 2014 .

[11]  Jinqiang Cui,et al.  UAV LiDAR for below-canopy forest surveys , 2013 .

[12]  Sven Behnke,et al.  A high-performance MAV for autonomous navigation in complex 3D environments , 2015, 2015 International Conference on Unmanned Aircraft Systems (ICUAS).

[13]  Jacob Willem Langelaan.  State estimation for autonomous flight in cluttered environments , 2006 .

[14]  Nicholas Roy,et al.  Stereo vision and laser odometry for autonomous helicopters in GPS-denied indoor environments , 2009, Defense + Commercial Sensing.

[15]  Andrea Censi,et al.  An ICP variant using a point-to-line metric , 2008, 2008 IEEE International Conference on Robotics and Automation.

[16]  Aaas News,et al.  Book Reviews , 1893, Buffalo Medical and Surgical Journal.

[17]  Juha Hyyppä,et al.  Outlook for the Next Generation’s Precision Forestry in Finland , 2014 .

[18]  Peidong Liu,et al.  Autonomous navigation of UAV in forest , 2014, 2014 International Conference on Unmanned Aircraft Systems (ICUAS).

[19]  Roland Siegwart,et al.  Introduction to Autonomous Mobile Robots , 2004 .

[20]  Mária Antalová,et al.  Precision Forestry – Definition and Technologies , 2010 .

[21]  Marc Pollefeys,et al.  An open source and open hardware embedded metric optical flow CMOS camera for indoor and outdoor applications , 2013, 2013 IEEE International Conference on Robotics and Automation.