Optimization of dual-loop exhaust gas recirculation splitting for a light-duty diesel engine with model-based control

The objective of this research was to develop dual-loop exhaust gas recirculation (EGR) split strategies. Model-based control was performed by coupling one-dimensional (1D) cycle simulation with control logic, and the EGR split index (ESI) was developed to investigate split effects on performance and emission. The key control logic concept was to compensate the low pressure (LP) EGR rate. Additionally, ESI, a newly developed index, is a non-dimensional factor expressing the high pressure (HP) and LP portions of the total EGR rate. Using the control model and ESI, the maximum EGR rates were determined under each operating condition, thereby maintaining lean burn combustion and minimizing NOX emission. A multi-objective Pareto method was used with the model-based control to optimize the engine operating parameters and thereby minimize NOX formation and fuel consumption. The control logic applied a step transient analysis based on the optimized parameters.

[1]  Giorgio Zamboni,et al.  Hybrid EGR and turbocharging systems control for low NOX and fuel consumption in an automotive diesel engine , 2016 .

[2]  M. Nakano,et al.  Effects of exhaust gas recirculation in homogeneous charge compression ignition engines , 2000 .

[3]  Tie Li,et al.  Characteristics of low temperature and low oxygen diesel combustion with ultra-high exhaust gas recirculation , 2007 .

[4]  Fengjun Yan,et al.  Control of diesel engine dual-loop EGR air-path systems by a singular perturbation method , 2013 .

[5]  Fengjun Yan,et al.  In-cylinder oxygen mass fraction cycle-by-cycle estimation via a lyapunov-based observer design , 2010, Proceedings of the 2010 American Control Conference.

[6]  K. Chun,et al.  Optimization of Diesel Engine Performance with Dual Loop EGR considering Boost Pressure, Back Pressure, Start of Injection and Injection Mass , 2010 .

[7]  Giorgio Zamboni,et al.  Experimental study on the effects of HP and LP EGR in an automotive turbocharged diesel engine , 2012 .

[8]  Junmin Wang,et al.  Control of dual-loop EGR engine air-path systems with adjustable intake manifold condition priorities , 2014, 2014 American Control Conference.

[9]  Jun Yu,et al.  Improvement of Fuel Economy and Transient Control in a Passenger Diesel Engine Using LP(Low Pressure)-EGR , 2011 .

[10]  Jungsoo Park,et al.  Numerical investigation of a dual-loop EGR split strategy using a split index and multi-objective Pareto optimization , 2015 .

[11]  Yongsheng He,et al.  Development and Validation of a 1D Model of a Turbocharged V6 Diesel Engine Operating Under Steady-State and Transient Conditions , 2005 .

[12]  U. Asad,et al.  Efficacy of EGR and Boost in Single-Injection Enabled Low Temperature Combustion , 2009 .

[13]  Xiaoye Han,et al.  Fuel Injection Strategies to Improve Emissions and Efficiency of High Compression Ratio Diesel Engines , 2008 .

[14]  Yui Nishio,et al.  Model Based Control for Dual EGR System with Intake Throttlein New Generation 1.6L Diesel Engine , 2013 .

[15]  Fengjun Yan,et al.  Control of a dual-loop exhaust gas recirculation system for a turbocharged Diesel engine , 2015 .

[16]  Keansub Lee,et al.  Numerical study of a light-duty diesel engine with a dual-loop EGR system under frequent engine operating conditions using the doe method , 2010 .

[17]  Xiangrui Zeng,et al.  A physics-based time-varying transport delay oxygen concentration model for dual-loop exhaust gas recirculation (EGR) engine air-paths , 2014 .

[18]  J. Chauvin,et al.  Intake System Diagnosis for Diesel Engine with Dual-Loop EGR , 2012 .

[19]  Cheolwoong Park,et al.  Effects of HPL and LPL EGR Gas Mixed Supply on Combustion and Emissions in Automotive Diesel Engine , 2011 .

[20]  H. Borhan,et al.  Air handling control of a diesel engine with a complex dual-loop EGR and VGT air system using MPC , 2015, 2015 American Control Conference (ACC).