Anatomic variation in the elastic anisotropy of cortical bone tissue in the human femur.

Experimental investigations for anatomic variation in the magnitude and anisotropy of elastic constants in human femoral cortical bone tissue have typically focused on a limited number of convenient sites near the mid-diaphysis. However, the proximal and distal ends of the diaphysis are more clinically relevant to common orthopaedic procedures and interesting mechanobiology. Therefore, the objective of this study was to measure anatomic variation in the elastic anisotropy and inhomogeneity of human cortical bone tissue along the entire length (15%-85% of the total femur length), and around the periphery (anterior, medial, posterior and lateral quadrants) of the femoral diaphysis, using ultrasonic wave propagation in the three orthogonal specimen axes. The elastic symmetry of tissue in the distal and extreme proximal portions of the diaphysis (15%-45% and 75%-85% of the total femur length, respectively) was, at most, orthotropic. In contrast, the elastic symmetry of tissue near the mid- and proximal mid-diaphysis (50%-70% of the total femur length) was reasonably approximated as transversely isotropic. The magnitudes of elastic constants generally reached maxima near the mid- and proximal mid-diaphysis in the lateral and medial quadrants, and decreased toward the epiphyses, as well as the posterior and anterior quadrants. The elastic anisotropy ratio in the longitudinal and radial anatomic axes showed the opposite trends. These variations were significantly correlated with the apparent tissue density, as expected. In summary, the human femur exhibited statistically significant anatomic variation in elastic anisotropy, which may have important implications for whole bone numerical models and mechanobiology.

[1]  G. Beaupré,et al.  The influence of bone volume fraction and ash fraction on bone strength and modulus. , 2001, Bone.

[2]  M Doblaré,et al.  Application of an anisotropic bone-remodelling model based on a damage-repair theory to the analysis of the proximal femur before and after total hip replacement. , 2001, Journal of biomechanics.

[3]  M Bagge,et al.  A model of bone adaptation as an optimization process. , 2000, Journal of biomechanics.

[4]  D. Burr,et al.  Contribution of collagen and mineral to the elastic anisotropy of bone , 1994, Calcified Tissue International.

[5]  J Y Rho,et al.  Anisotropic properties of human tibial cortical bone as measured by nanoindentation , 2002, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[6]  S. Goldstein,et al.  Elastic modulus and hardness of cortical and trabecular bone lamellae measured by nanoindentation in the human femur. , 1999, Journal of biomechanics.

[7]  J Y Rho,et al.  Elastic properties of microstructural components of human bone tissue as measured by nanoindentation. , 1999, Journal of biomedical materials research.

[8]  Sabine Bensamoun,et al.  Spatial distribution of acoustic and elastic properties of human femoral cortical bone. , 2004, Journal of biomechanics.

[9]  F. G. Evans,et al.  Regional differences in some of the physical properties of the human femur. , 1951, Journal of applied physiology.

[10]  R. Pidaparti,et al.  The anisotropy of osteonal bone and its ultrastructural implications. , 1995, Bone.

[11]  W. Bonfield,et al.  Anisotropy of the Young's modulus of bone , 1977, Nature.

[12]  A. Burstein,et al.  The Mechanical Properties of Cortical Bone , 1974 .

[13]  G S Beaupré,et al.  Computer predictions of bone remodeling around porous-coated implants. , 1990, The Journal of arthroplasty.

[14]  J. Rho,et al.  Anisotropy of Young's modulus of human tibial cortical bone , 2000, Medical and Biological Engineering and Computing.

[15]  Rik Huiskes,et al.  Why mechanobiology? A survey article. , 2002, Journal of biomechanics.

[16]  Y. Yamato,et al.  Distribution of longitudinal wave properties in bovine cortical bone in vitro. , 2006, Ultrasonics.

[17]  J. Rho An ultrasonic method for measuring the elastic properties of human tibial cortical and cancellous bone. , 1996, Ultrasonics.

[18]  R. B. Ashman,et al.  Relations of mechanical properties to density and CT numbers in human bone. , 1995, Medical engineering & physics.

[19]  W. Taylor,et al.  Physiologically based boundary conditions in finite element modelling. , 2007, Journal of biomechanics.

[20]  X Edward Guo,et al.  The dependence of transversely isotropic elasticity of human femoral cortical bone on porosity. , 2004, Journal of biomechanics.

[21]  S. Lang,et al.  Ultrasonic method for measuring elastic coefficients of bone and results on fresh and dried bovine bones. , 1970, IEEE transactions on bio-medical engineering.

[22]  W C Van Buskirk,et al.  A continuous wave technique for the measurement of the elastic properties of cortical bone. , 1984, Journal of biomechanics.

[23]  R. B. Ashman,et al.  Young's modulus of trabecular and cortical bone material: ultrasonic and microtensile measurements. , 1993, Journal of biomechanics.

[24]  M. S. King,et al.  Determination of Elastic Constants for Human Femurs , 1979 .

[25]  D B Burr,et al.  Elastic anisotropy and collagen orientation of osteonal bone are dependent on the mechanical strain distribution , 1999, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[26]  G. Pharr,et al.  Microstructural elasticity and regional heterogeneity in human femoral bone of various ages examined by nano-indentation. , 2002, Journal of biomechanics.

[27]  Kay Raum,et al.  Assessment of composition and anisotropic elastic properties of secondary osteon lamellae. , 2006, Journal of biomechanics.

[28]  K. Hunt,et al.  Ultrasonic determination of the elastic modulus of human cortical bone , 2006, Medical and Biological Engineering and Computing.

[29]  G. Pharr,et al.  Variations in the individual thick lamellar properties within osteons by nanoindentation. , 1999, Bone.

[30]  Weimin Yue,et al.  Specimen-specific multi-scale model for the anisotropic elastic constants of human cortical bone. , 2009, Journal of biomechanics.

[31]  J O Outwater,et al.  Mechanical properties of bone as a function of position and orientation. , 1974, Journal of biomechanics.

[32]  G. Pharr,et al.  Effects of anisotropy on elastic moduli measured by nanoindentation in human tibial cortical bone. , 2001, Journal of biomedical materials research.

[33]  C. Turner,et al.  Dissociation of mineral and collagen orientations may differentially adapt compact bone for regional loading environments: results from acoustic velocity measurements in deer calcanei. , 2006, Bone.

[34]  Y. Yamato,et al.  Distribution of Longitudinal Wave Velocities in Bovine Cortical Bone in vitro , 2005 .

[35]  E Y Chao,et al.  Internal forces and moments in the femur during walking. , 1997, Journal of biomechanics.

[36]  W C Van Buskirk,et al.  Ultrasonic measurement of orthotropic elastic constants of bovine femoral bone. , 1981, Journal of biomechanical engineering.

[37]  A. Meunier,et al.  A generalized method for characterizing elastic anisotropy in solid living tissues , 1990 .

[38]  M Viceconti,et al.  The muscle standardized femur: A step forward in the replication of numerical studies in biomechanics , 2003, Proceedings of the Institution of Mechanical Engineers. Part H, Journal of engineering in medicine.

[39]  D. Burr,et al.  Stiffness of compact bone: effects of porosity and density. , 1988, Journal of biomechanics.

[40]  W. T. Dempster,et al.  Compact bone as a non-isotropic material. , 1952, The American journal of anatomy.

[41]  M. Warner,et al.  Determination of orthotropic bone elastic constants using FEA and modal analysis. , 2002, Journal of biomechanics.

[42]  T. Keller,et al.  Young's modulus, bending strength, and tissue physical properties of human compact bone , 1990, Journal of orthopaedic research : official publication of the Orthopaedic Research Society.

[43]  R. Roeder,et al.  Micromechanical model for hydroxyapatite whisker reinforced polymer biocomposites , 2006 .

[44]  J. C. Simo,et al.  Adaptive bone remodeling incorporating simultaneous density and anisotropy considerations. , 1997, Journal of biomechanics.

[45]  E. Schneider,et al.  Influence of muscle forces on femoral strain distribution. , 1998, Journal of biomechanics.

[46]  J. Katz,et al.  Ultrasonic wave propagation in human cortical bone--II. Measurements of elastic properties and microhardness. , 1976, Journal of biomechanics.

[47]  S C Cowin,et al.  Identification of the elastic symmetry of bone and other materials. , 1989, Journal of biomechanics.

[48]  E. Amtmann The distribution of breaking strength in the human femur shaft. , 1968, Journal of biomechanics.

[49]  A. Burstein,et al.  The elastic and ultimate properties of compact bone tissue. , 1975, Journal of biomechanics.

[50]  J. Katz,et al.  Ultrasonic wave propagation in human cortical bone-I. Theoretical considerations for hexagonal symmetry. , 1976, Journal of biomechanics.

[51]  P. Christel,et al.  The effects of remodeling on the elastic properties of bone , 2006, Calcified Tissue International.