Computationally rapid method of estimating signal‐to‐noise ratio for phased array image reconstructions

Measuring signal‐to‐noise ratio (SNR) for parallel MRI reconstructions is difficult due to spatially dependent noise amplification. Existing approaches for measuring parallel MRI SNR are limited because they are not applicable to all reconstructions, require significant computation time, or rely on repeated image acquisitions. A new SNR estimation approach is proposed, a hybrid of the repeated image acquisitions method detailed in the National Electrical Manufacturers Association (NEMA) standard and the Monte Carlo based pseudo‐multiple replica method, in which the difference between images reconstructed from the unaltered acquired data and that same data reconstructed after the addition of calibrated pseudo‐noise is used to estimate the noise in the parallel MRI image reconstruction. This new noise estimation method can be used to rapidly compute the pixel‐wise SNR of the image generated from any parallel MRI reconstruction of a single acquisition. SNR maps calculated with the new method are validated against existing SNR calculation techniques. Magn Reson Med, 2011. © 2011 Wiley‐Liss, Inc.

[1]  B. Rutt,et al.  Rapid combined T1 and T2 mapping using gradient recalled acquisition in the steady state , 2003, Magnetic resonance in medicine.

[2]  S. Schoenberg,et al.  Practical approaches to the evaluation of signal‐to‐noise ratio performance with parallel imaging: Application with cardiac imaging and a 32‐channel cardiac coil , 2005, Magnetic resonance in medicine.

[3]  D. Sodickson,et al.  Comprehensive quantification of signal‐to‐noise ratio and g‐factor for image‐based and k‐space‐based parallel imaging reconstructions , 2008, Magnetic resonance in medicine.

[4]  S. Schoenberg,et al.  Measurement of signal‐to‐noise ratios in MR images: Influence of multichannel coils, parallel imaging, and reconstruction filters , 2007, Journal of magnetic resonance imaging : JMRI.

[5]  Martin Blaimer,et al.  Non‐Cartesian data reconstruction using GRAPPA operator gridding (GROG) , 2007, Magnetic resonance in medicine.

[6]  Peter Kellman,et al.  Image reconstruction in SNR units: A general method for SNR measurement † , 2005, Magnetic resonance in medicine.

[7]  SNR Quantification with Phased-Array Coils and Parallel Imaging for 3 D-FSE , 2009 .

[8]  P. Boesiger,et al.  SENSE: Sensitivity encoding for fast MRI , 1999, Magnetic resonance in medicine.

[9]  P. Boesiger,et al.  Advances in sensitivity encoding with arbitrary k‐space trajectories , 2001, Magnetic resonance in medicine.

[10]  S. Schoenberg,et al.  Influence of multichannel combination, parallel imaging and other reconstruction techniques on MRI noise characteristics. , 2008, Magnetic resonance imaging.

[11]  Robin M Heidemann,et al.  Generalized autocalibrating partially parallel acquisitions (GRAPPA) , 2002, Magnetic resonance in medicine.

[12]  L. Ying,et al.  A new single acquisition, two-image difference method for determining MR image SNR. , 2009, Medical physics.

[13]  W. Manning,et al.  Simultaneous acquisition of spatial harmonics (SMASH): Fast imaging with radiofrequency coil arrays , 1997, Magnetic resonance in medicine.