Karanja oil utilization in a direct-injection engine by preheating. Part 2: experimental investigations of engine durability and lubricating oil properties

Abstract Straight vegetable oil utilization as a diesel engine fuel has the advantages of eliminating the energy, time, and cost involved in biodiesel production. Since straight vegetable oils have quite high viscosity compared with mineral diesel, they have to be modified to bring their combustion-related properties closer to mineral diesel. In this experimental study, a heat exchanger was designed and used to utilize the waste heat of exhaust gases for reducing the viscosity of Karanja oil by preheating. Carbon deposits, wear of vital engine components, and various effects of utilizing preheated Karanja oil on lubricating oil were analysed during a long-term endurance test executed for 512h. Carbon deposits on various critical parts of the power cell were analysed by visual inspection. For pistons, the piston merit rating was determined. The effect on a lubricating oil because of heated Karanja oil vis-à-vis mineral diesel was evaluated by comparing the densities, viscosities, flash points, carbon residues, ash contents, copper corrosion effect and pentane, benzene insolubility measurements at intervals of every 128h for 512h. The wear of the cylinder liner, piston rings, gudgeon pin, and small- and big-end bearings for a Karanja-oil-fuelled engine were also measured and compared vis-à-vis mineral diesel-fuelled engine.

[1]  Avinash Kumar Agarwal,et al.  Biodiesel Development and Characterization for Use as a Fuel in Compression Ignition Engines , 2001 .

[2]  P Mahanta,et al.  An experimental study of Pongamia pinnata L. oil as a diesel substitute , 2006 .

[3]  O. M. I. Nwafor,et al.  Emission characteristics of diesel engine running on vegetable oil with elevated fuel inlet temperature , 2004 .

[4]  A. Ramesh,et al.  An experimental comparison of methods to use methanol and Jatropha oil in a compression ignition engine , 2003 .

[5]  R. S. Hosmath,et al.  Performance and emission characteristics of a DI compression ignition engine operated on Honge, Jatropha and sesame oil methyl esters , 2008 .

[6]  K. Openshaw.  A review of Jatropha curcas: an oil plant of unfulfilled promise☆ , 2000 .

[7]  M. Kegl,et al.  Biodiesel influence on tribology characteristics of a diesel engine , 2009 .

[8]  Avinash Kumar Agarwal,et al.  Biofuels (alcohols and biodiesel) applications as fuels for internal combustion engines , 2007 .

[9]  C. Muraleedharan,et al.  Use of vegetable oils as I.C. engine fuels—A review , 2004 .

[10]  Gvidonas Labeckas,et al.  Performance of direct-injection off-road diesel engine on rapeseed oil , 2006 .

[11]  A. Agarwal,et al.  Experimental investigations of performance and emissions of Karanja oil and its blends in a single cylinder agricultural diesel engine , 2009 .

[12]  Aw Drews,et al.  Standard Test Method for Ash from Petroleum Products , 1998 .

[13]  S. Bari,et al.  Effects of preheating of crude palm oil (CPO) on injection system, performance and emission of a diesel engine , 2002 .

[14]  Carlos R. P. Belchior,et al.  Performance of a diesel generator fuelled with palm oil , 2002 .

[15]  Aw Drews,et al.  Standard Test Method for Conradson Carbon Residue of Petroleum Products , 1998 .