Fluid-electrostatic-mechanical modeling of the dynamic response of RF-MEMS capacitive switches

For predicting dynamic responses of electrostatically actuated RF-MEMS it is imperative to be able to include fluid squeeze film effects (air damping) in a directly coupled electrostatic-mechanical model, in an efficient and accurate way. This paper presents the modeling methodology to predict the dynamic response of a capacitive RF-MEMS obtained with implementation of a isothermal non-linear compressible Reynolds equation in a directly coupled fluid-structural element in a pre-release of the Ansys FE software. Multi-physics simulations of harmonic (AC) responses and transient switching cycles, in which the switch closes and non-linear contact is included, were validated with measurements. It is concluded that the presented multi-physics model is a powerful tool for virtual device design and indispensable for predicting functional performance of RF-MEMS. This model provides more accurate transient results than models based on the linearized Reynolds equations.

[1]  T. Veijola,et al.  Compact Squeezed-Film Damping Model for Perforated Surface , 2001 .

[2]  T. Veijola,et al.  Gas damping model for a RF MEM switch and its dynamic characteristics , 2002, 2002 IEEE MTT-S International Microwave Symposium Digest (Cat. No.02CH37278).

[3]  Timo Veijola,et al.  The influence of gas-surface interaction on gas-film damping in a silicon accelerometer , 1998 .

[4]  George G. Adams,et al.  A dynamic model, including contact bounce, of an electrostatically actuated microswitch , 2002 .

[5]  Rudra Pratap,et al.  Effect of flexural modes on squeeze film damping in MEMS cantilever resonators , 2007 .

[6]  R. W. Herfst,et al.  Center-Shift Method for the Characterization of Dielectric Charging in RF MEMS Capacitive Switches , 2008, IEEE Transactions on Semiconductor Manufacturing.

[7]  S.D. Senturia,et al.  Computer-aided generation of nonlinear reduced-order dynamic macromodels. I. Non-stress-stiffened case , 2000, Journal of Microelectromechanical Systems.

[8]  G.G. Adams,et al.  Modeling and Measurement of the Dynamic Performance of an OHMIC Contact-Type RF MEMS Switch , 2007, TRANSDUCERS 2007 - 2007 International Solid-State Sensors, Actuators and Microsystems Conference.

[9]  T. Veijola,et al.  Model for gas film damping in a silicon accelerometer , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[10]  J.T.M. van Beek,et al.  MEMS for wireless communication: application, technology, opportunities and issues , 2006 .

[11]  B. Schauwecker,et al.  Reduced order modeling of fluid structural interactions in MEMS based on model projection techniques , 2003, TRANSDUCERS '03. 12th International Conference on Solid-State Sensors, Actuators and Microsystems. Digest of Technical Papers (Cat. No.03TH8664).

[12]  Robert Puers,et al.  Dynamics and squeeze film gas damping of a capacitive RF MEMS switch , 2005 .

[13]  S. Senturia,et al.  Pull-in time dynamics as a measure of absolute pressure , 1997, Proceedings IEEE The Tenth Annual International Workshop on Micro Electro Mechanical Systems. An Investigation of Micro Structures, Sensors, Actuators, Machines and Robots.

[14]  Timo Veijola,et al.  Transient capacitance measurement of MEM capacitor , 2005 .

[15]  S. Senturia.  Microsystem Design , 2000 .

[16]  V. Burg,et al.  Characterization Method for Mechanical Properties of Thin Freestanding Metal Films for RF-MEMS , 2006, EuroSime 2006 - 7th International Conference on Thermal, Mechanical and Multiphysics Simulation and Experiments in Micro-Electronics and Micro-Systems.

[17]  S. Senturia,et al.  Computer-aided generation of nonlinear reduced-order dynamic macromodels. II. Stress-stiffened case , 2000, Journal of Microelectromechanical Systems.

[18]  J. Schmitz,et al.  Time and voltage dependence of dielectric charging in RF MEMS capacitive switches , 2007, 2007 IEEE International Reliability Physics Symposium Proceedings. 45th Annual.

[19]  S. D. Senturia,et al.  Generating efficient dynamical models for microelectromechanical systems from a few finite-element simulation runs , 1999 .

[20]  W. A. Gross,et al.  Fluid film lubrication , 1980 .

[21]  T. Veijola,et al.  Circuit Simulation Model Of Gas Damping In Microstructures With Nontrivial Geometries , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[22]  H. Tilmans.  Equivalent circuit representation of electromechanical transducers: I. Lumped-parameter systems , 1996 .

[23]  H.G.A. Huizing,et al.  Characterization of dielectric charging in RF MEMS capacitive switches , 2006, 2006 IEEE International Conference on Microelectronic Test Structures.

[24]  J. Stulemeijer,et al.  Efficient electrostatic-mechanical modeling of C-V curves of RF-MEMS switches , 2007, 2007 International Conference on Thermal, Mechanical and Multi-Physics Simulation Experiments in Microelectronics and Micro-Systems. EuroSime 2007.

[25]  R. Pratap,et al.  Influence of Boundary Conditions on the Dynamic Characteristics of Squeeze Films in MEMS Devices , 2007, Journal of Microelectromechanical Systems.