A comparison between two switching policies for two-unit standby system

The standby has been widely applied to improve the reliability of system. And the standby unit is usually activated only when the active units fail under the common switching policy. But it would not always make the system most reliable. In this paper, based on a two-unit standby system without repair, we introduce the active switching policy in which the standby unit is activated at either a pre-fixed time or the failure time of active unit. Considering the perfect and imperfect switching, the survival function and mean time to failure of system are derived using the general time-to-failure distribution under the active and common switching policy, respectively. Further, if the lifetimes of units follow the exponential distribution, the cases where the active switching policy is superior are specified clearly. For the Weibull distribution, an application example is presented and it demonstrates that the active switching policy sometimes is still superior. Besides, the essence of the active switching policy and the reason why it is more effective are simply discussed. The study proves that it is likely to make the system more reliable by adopting other switching policy rather than the common one.

[1]  Norman E. Fenton,et al.  Improved reliability modeling using Bayesian networks and dynamic discretization , 2010, Reliab. Eng. Syst. Saf..

[2]  Wei Huang,et al.  A reliability model of a warm standby configuration with two identical sets of units , 2015, Reliab. Eng. Syst. Saf..

[3]  Gregory Levitin,et al.  Reliability and Mission Cost of 1-Out-of-$N$:G Systems With State-Dependent Standby Mode Transfers , 2015, IEEE Transactions on Reliability.

[4]  Amir Abbas Najafi,et al.  An efficient simulated annealing algorithm for the redundancy allocation problem with a choice of redundancy strategies , 2013, Reliab. Eng. Syst. Saf..

[5]  Ji Hwan Cha,et al.  Optimal design of a general warm standby system , 2010, Reliab. Eng. Syst. Saf..

[6]  Ali Zeinal Hamadani,et al.  Reliability optimization of series-parallel systems with mixed redundancy strategy in subsystems , 2014, Reliab. Eng. Syst. Saf..

[7]  Joanne Bechta Dugan,et al.  A discrete-time Bayesian network reliability modeling and analysis framework , 2005, Reliab. Eng. Syst. Saf..

[8]  Rui Peng,et al.  A Study of Optimal Component Order in a General 1-Out-of-$n$ Warm Standby System , 2015, IEEE Transactions on Reliability.

[9]  Hoang Pham,et al.  Reliability Characteristics of k-out-of-n Warm Standby Systems , 2012, IEEE Trans. Reliab..

[10]  Charles E. Wells,et al.  Reliability analysis of a single warm-standby system subject to repairable and nonrepairable failures , 2014, Eur. J. Oper. Res..

[11]  Donghua Zhou,et al.  Condition-based switching and replacement policies for a two-unit warm standby redundant system subject to non-instantaneous switchover , 2014 .

[12]  Gregory Levitin,et al.  Optimal component loading in 1-out-of-N cold standby systems , 2014, Reliab. Eng. Syst. Saf..

[13]  Haibo Jin,et al.  A novel optimal preventive maintenance policy for a cold standby system based on semi-Markov theory , 2014, Eur. J. Oper. Res..

[14]  Serkan Eryilmaz,et al.  On the mean residual life of a k-out-of-n: G system with a single cold standby component , 2012, Eur. J. Oper. Res..

[15]  Bo Guo,et al.  Analysis of non-repairable cold-standby systems in Bayes theory , 2016 .

[16]  Liudong Xing,et al.  A fast approximation method for reliability analysis of cold-standby systems , 2012, Reliab. Eng. Syst. Saf..

[17]  Serkan Eryilmaz Reliability of a K-Out-of-n System Equipped With a Single Warm Standby Component , 2013, IEEE Transactions on Reliability.

[18]  Jie Mi,et al.  On the timing to switch on the standby in k-out-of-n:G redundant systems , 2015 .

[19]  Lirong Cui,et al.  A cold standby repairable system with working vacations and vacation interruption following Markovian arrival process , 2015, Reliab. Eng. Syst. Saf..

[20]  Heinz-Peter Berg,et al.  Markov analysis of redundant standby safety systems under periodic surveillance testing , 2015, Reliab. Eng. Syst. Saf..

[21]  Jie Mi,et al.  Modelling a general standby system and evaluation of its performance , 2008 .

[22]  Hyun Gook Kang,et al.  Surveillance test and monitoring strategy for the availability improvement of standby equipment using age-dependent model , 2015, Reliab. Eng. Syst. Saf..