Application of ALD-Al 2 O 3 in CdS/CdTe Thin-Film Solar Cells

The application of thinner cadmium sulfide (CdS) window layer is a feasible approach to improve the performance of cadmium telluride (CdTe) thin film solar cells. However, the reduction of compactness and continuity of thinner CdS always deteriorates the device performance. In this work, transparent Al 2 O 3 films with different thicknesses, deposited by using atomic layer deposition (ALD), were utilized as buffer layers between the front electrode transparent conductive oxide (TCO) and CdS layers to solve this problem, and then, thin-film solar cells with a structure of TCO/Al 2 O 3 /CdS/CdTe/BC/Ni were fabricated. The characteristics of the ALD-Al 2 O 3 films were studied by UV–visible transmittance spectrum, Raman spectroscopy, and atomic force microscopy (AFM). The light and dark J–V performances of solar cells were also measured by specific instrumentations. The transmittance measurement conducted on the TCO/Al 2 O 3 films verified that the transmittance of TCO/Al 2 O 3 were comparable to that of single TCO layer, meaning that no extra absorption loss occurred when Al 2 O 3 buffer layers were introduced into cells. Furthermore, due to the advantages of the ALD method, the ALD-Al 2 O 3 buffer layers formed an extremely continuous and uniform coverage on the substrates to effectively fill and block the tiny leakage channels in CdS/CdTe polycrystalline films and improve the characteristics of the interface between TCO and CdS. However, as the thickness of alumina increased, the negative effects of cells were gradually exposed, especially the increase of the series resistance (R s ) and the more serious “roll-over” phenomenon. Finally, the cell conversion efficiency (η) of more than 13.0% accompanied by optimized uniformity performances was successfully achieved corresponding to the 10 nm thick ALD-Al 2 O 3 thin film.

[1]  Faisal M. Alamgir,et al.  Band alignment of front contact layers for high-efficiency CdTe solar cells , 2016 .

[2]  D. Kuciauskas,et al.  Sputter-Deposited Oxides for Interface Passivation of CdTe Photovoltaics , 2018, IEEE Journal of Photovoltaics.

[3]  F. Gao,et al.  Determination of surface oxygen vacancy position in SnO2 nanocrystals by Raman spectroscopy , 2011 .

[4]  Ki-Young Oh,et al.  Effects of ozone as an oxygen source on the properties of the Al2O3 thin films prepared by atomic layer deposition , 2003 .

[5]  Qingfeng Liu,et al.  Plasmonic three-dimensional transparent conductor based on Al-doped zinc oxide-coated nanostructured glass using atomic layer deposition. , 2015, ACS applied materials & interfaces.

[6]  Wmm Erwin Kessels,et al.  Surface passivation of high‐efficiency silicon solar cells by atomic‐layer‐deposited Al2O3 , 2008 .

[7]  Shyama Rath,et al.  Nanoparticle size, oxidation state, and sensing response of tin oxide nanopowders using Raman spectroscopy , 2014 .

[8]  Lili Wu,et al.  Preparation and Properties of SnO2 Film Deposited by Magnetron Sputtering , 2012 .

[9]  W. Jaegermann,et al.  CdTe thin film solar cells with reduced CdS film thickness , 2011 .

[10]  Steven M. George,et al.  Al2O3 Atomic Layer Deposition with Trimethylaluminum and Ozone Studied by in Situ Transmission FTIR Spectroscopy and Quadrupole Mass Spectrometry , 2008 .

[11]  Wenwu Wang,et al.  Correlation of Interfacial Transportation Properties of CdS/CdTe Heterojunction and Performance of CdTe Polycrystalline Thin-Film Solar Cells , 2015 .

[12]  K. Shen,et al.  Roll-over behavior in current-voltage curve introduced by an energy barrier at the front contact in thin film CdTe solar cell , 2018 .

[13]  Jan Benick,et al.  High-Efficiency c-Si Solar Cells Passivated With ALD and PECVD Aluminum Oxide , 2010, IEEE Electron Device Letters.

[14]  Z. Qiu,et al.  Direct growth of high-quality Al2O3 dielectric on graphene layers by low-temperature H2O-based ALD , 2014 .

[15]  J. Gray.  The Physics of the Solar Cell , 2011 .

[16]  L. Bing,et al.  Effect of ZnTe/ZnTe:Cu complex back-contact on device characteristics of CdTe solar cells , 2007 .

[17]  Kai-Chiang Yang,et al.  Hydrophilic/hydrophobic surface of Al 2 O 3 thin films grown by thermal and plasma-enhanced atomic layer deposition on plasticized polyvinyl chloride (PVC) , 2016 .

[18]  J. Jeon,et al.  Hydrophobic Surface Treatment and Interrupted Atomic Layer Deposition for Highly Resistive Al2O3 Films on Graphene. , 2016, ACS applied materials & interfaces.

[19]  A. Lamperti,et al.  Interface phenomena between CdTe and ZnTe:Cu back contact , 2018, Solar Energy.

[20]  J. Battaglia,et al.  High Temperature Thermal Conductivity of Amorphous Al2O3 Thin Films Grown by Low Temperature ALD , 2013 .

[21]  C. H. Bhosale,et al.  Electrical, structural and optical properties of SnO2:F thin films: Effect of the substrate temperature , 2009 .

[22]  Hirata,et al.  Concentration dependence of optical phonons in the TiO2-SnO2 system. , 1996, Physical review. B, Condensed matter.

[23]  Xuanzhi Wu,et al.  High-efficiency polycrystalline CdTe thin-film solar cells , 2004 .

[24]  H. Birey.  Thickness dependence of the dielectric constant and resistance of Al2O3 films , 1977 .

[25]  Mikko Ritala,et al.  Crystallinity of Inorganic Films Grown by Atomic Layer Deposition: Overview and General Trends , 2013 .