Electrostriction is based on the variation of permittivity of a dielectric material when subjected to mechanical strain. Until now, the use of electrostrictive materials is limited to the actuation of Micro Electro Mechanical Systems (MEMS) operating mostly in static mode. Here, we present the use of electrostriction as integrated transduction scheme in organic microcantilevers operating in both static and dynamic modes. Also, an innovative low-cost and environment friendly process using xurography is developed for the simple fabrication of MEMS in an all-organic approach. Electromechanical characterization of the organic microcantilevers is performed with the aim of validating this new concept using an original composite material based on functionalized graphene oxide (GO) dispersed in a polydimethylsiloxane (PDMS) elastomer. This material is characterized by a dielectric permittivity thousand times larger than that of pure PDMS. The electrostrictive composite shows good performances when the microcantilever is bent, with a variation of capacitance exceeding 4 % for low strain values (<; 1 %). Also, the integrated electrical detection of the microcantilever's resonant frequency (≤ 300 Hz) makes these devices suitable for mechanical energy harvesting. Trapezoidal shaped microcantilevers incorporating a seismic mass at its end give the best results with a resonant frequency of ~ 15 Hz and electromechanical performance 100 times greater than that of rectangular ones.
[1]
Benjamin Caillard,et al.
Fast-fabrication process for low environmental impact microsystems
,
2015
.
[2]
Tanja Schilling,et al.
Graphene liquid crystal retarded percolation for new high-k materials
,
2015,
Nature Communications.
[3]
Eric M. Yeatman,et al.
Micro Energy Harvesting
,
2015
.
[4]
P. Poulin,et al.
Highly piezoresistive hybrid MEMS sensors
,
2014
.
[5]
Jan M. Rabaey,et al.
Energy Scavenging for Wireless Sensor Networks: with Special Focus on Vibrations
,
2012
.
[6]
D. Guyomar,et al.
Electrostrictive polymers for mechanical energy harvesting
,
2012
.
[7]
A. Boisen,et al.
Cantilever-like micromechanical sensors
,
2011
.
[8]
J. Dugundji,et al.
Modeling and experimental verification of proof mass effects on vibration energy harvester performance
,
2010
.
[9]
M. Maugey,et al.
An Experimental Approach to the Percolation of Sticky Nanotubes
,
2005,
Science.
[10]
Eugenio Brusa,et al.
Vibration energy scavenging via piezoelectric bimorphs of optimized shapes
,
2010
.