Mode Identification for Rotating Rigid Shaft with Flexible Disks by Mode Splits

This paper investigates the mode splits of the bending coupled modes of a rotating shaft with multiple flexible disks, in which the disks are rigidly attached to the rigid shaft supported by bearings. The bending coupled modes, in which shaft bending modes are coupled with one nodal diameter disk modes, are classified as the balanced and unbalanced modes. The mode splits of the balanced modes are the same as those of pure disk modes since the shaft does not experience any motion. On the other hand, the mode splits between pairs of the forward and backward unbalanced modes are found to be dependent upon the disk/shaft configuration and the shaft support stiffness, as well as the rotational speed and the ratio of polar to diametrical moment of inertia.

[1]  Chong-Won Lee,et al.  Vibration Analysis of Rotors , 1994 .

[2]  T. E. Shoup,et al.  Rotor Resonant Speed Reduction Caused by Flexibility of Disks , 1974 .

[3]  David B. Bogy,et al.  Natural Frequencies and Stability of a Flexible Spinning Disk-Stationary Load System With Rigid-Body Tilting , 1993 .

[4]  C. D. Mote.  Stability of circular plates subjected to moving loads , 1970 .

[5]  J. Kirkhope,et al.  Vibration and stress analysis of thin rotating discs using annular finite elements , 1976 .

[6]  A. L. Schlack,et al.  Effects of Disk Flexibility on Shaft Whirl Stability , 1979 .

[7]  S. A. Tobias,et al.  The Influence of Dynamical Imperfection on the Vibration of Rotating Disks , 1957 .

[8]  J. Thomas,et al.  Coupling effects of disc flexibility on the dynamic behaviour of multi disc-shaft systems , 1987 .

[9]  K. Kimura,et al.  Vibration of Bladed Flexible Rotor Due to Gyroscopic Moment , 1987 .

[10]  C. D. Mote.  Moving‐load stability of a circular plate on a floating central collar , 1977 .

[11]  George T. Flowers,et al.  Development of a set of equations for incorporating disk flexibility effects in rotordynamic analyses , 1993 .

[12]  Shih-Ming Yang.  Vibration of a spinning annular disk with coupled rigid body motion , 1993 .

[13]  H. D. Nelson,et al.  The Natural Frequencies and Critical Speeds of a Rotating, Flexible Shaft-Disk System , 1975 .

[14]  George T. Flowers,et al.  A Transfer Matrix Technique for Evaluating the Natural Frequencies and Critical Speeds of a Rotor With Multiple Flexible Disks , 1992 .

[15]  Hiroshi Matsuhisa,et al.  Modal response of a disk to a moving concentrated harmonic force , 1985 .

[16]  Wilfred D. Iwan,et al.  The Stability of a Spinning Elastic Disk With a Transverse Load System , 1976 .

[17]  Chong-Won Lee,et al.  Prediction of Coupled Vibrations in Hard Disk Drive Spindle Systems , 1997 .

[18]  D. Bogy,et al.  Effects of Load Parameters on the Natural Frequencies and Stability of a Flexible Spinning Disk With a Stationary Load System , 1992 .

[19]  Clark J. Radcliffe,et al.  Identification and Control of Rotating Disk Vibration , 1983 .

[20]  Chong-Won Lee,et al.  SEPARATION AND IDENTIFICATION OF TRAVELLING WAVE MODES IN ROTATING DISK VIA DIRECTIONAL SPECTRAL ANALYSIS , 1995 .

[21]  I. Y. Shen,et al.  A Nonclassical Vibration Analysis of a Multiple Rotating Disk and Spindle Assembly , 1997 .