Cutting Forces Analysis in Additive Manufactured AISI H13 Alloy
暂无分享,去创建一个
Gianni Campatelli | Niccolò Grossi | Antonio Scippa | Hiroyuki Sasahara | Hisataka Takagi | H. Sasahara | Filippo Montevecchi | H. Takagi | F. Montevecchi | G. Campatelli | A. Scippa | N. Grossi
[1] Gianni Campatelli,et al. Milled Surface Generation Model for Chip Thickness Detection in Peripheral Milling , 2013 .
[2] Yusuf Altintas,et al. Generalized Modeling of Mechanics and Dynamics of Milling Cutters , 2001 .
[3] Zengxi Pan,et al. Wire-feed additive manufacturing of metal components: technologies, developments and future interests , 2015 .
[4] Stefania Bruschi,et al. Analysis of tool wear in cryogenic machining of additive manufactured Ti6Al4V alloy , 2015 .
[5] S. Bruschi,et al. Machinability Characteristics of Wrought and EBM CoCrMo Alloys , 2014 .
[6] Gianni Campatelli,et al. Improved dynamic compensation for accurate cutting force measurements in milling applications , 2015 .
[7] Ryuta Sato,et al. Spindle speed ramp-up test: A novel experimental approach for chatter stability detection , 2015 .
[8] Gianni Campatelli,et al. Chatter Stability Prediction in Milling Using Speed-varying Cutting Force Coefficients☆ , 2014 .
[9] R. Kovacevic,et al. Investigation of Thermal Cycle and Hardness Distribution in the Laser Cladding of AISI H13 Tool Steel Produced by a High Power Direct Diode Laser , 2013 .
[10] Gianni Campatelli,et al. Speed-varying cutting force coefficient identification in milling , 2015 .
[11] Imtiaz Ahmed Choudhury,et al. Machinability assessment of inconel 718 by factorial design of experiment coupled with response surface methodology , 1999 .
[12] Gianni Campatelli,et al. FEM based cutting velocity selection for thin walled part machining , 2014 .