An investigation of cutting forces and surface damage in high-speed turning of inconel 718

[1]  Madhan Shridhar Phadke,et al.  Quality Engineering Using Robust Design , 1989 .

[2]  G. Boothroyd,et al.  Fundamentals of machining and machine tools , 2006 .

[3]  B. K. Subhas,et al.  Dimensional instability studies in machining of Inconel 718 nickel based superalloy as applied to aerogas turbine components , 2000 .

[4]  A. Sadat,et al.  Surface region damage of machined inconel-718 nickel-base superalloy using natural and controlled contact length tools , 1987 .

[5]  Reginaldo Teixeira Coelho,et al.  Some effects of cutting edge preparation and geometric modifications when turning INCONEL 718™ at high cutting speeds , 2004 .

[6]  E. Ezugwu,et al.  An overview of the machinability of aeroengine alloys , 2003 .

[7]  Norihiko Narutaki,et al.  High-speed Machining of Inconel 718 with Ceramic Tools , 1993 .

[8]  Muammer Nalbant,et al.  The effect of cutting speed and cutting tool geometry on machinability properties of nickel-base Inconel 718 super alloys , 2007 .

[9]  E. Ezugwu,et al.  Surface abuse when machining cast iron (G-17) and nickel-base superalloy (Inconel 718) with ceramic tools , 1995 .

[10]  S. Darwish.  The impact of the tool material and the cutting parameters on surface roughness of supermet 718 nickel superalloy , 2000 .

[11]  Y. Shin,et al.  Laser-assisted machining of Inconel 718 with an economic analysis , 2006 .

[12]  Mahmudur Rahman,et al.  The machinability of inconel 718 , 1997 .

[13]  M. A. Mannan,et al.  High speed facing of age hardened Inconel 718 using silicon carbide whisker reinforced ceramic tools , 2002 .

[14]  M. A. Mannan,et al.  Residual stress and surface roughness when facing age hardened Inconel 718 with CBN and ceramic cutting tools , 2004 .

[15]  Anil Mital,et al.  Surface finish prediction models for fine turning , 1988 .

[16]  A. Sadat,et al.  Plastic deformation analysis in machining of Inconel-718 nickel-base superalloy using both experimental and numerical methods , 1991 .

[17]  M. C. Shaw.  Metal Cutting Principles , 1960 .