Modeling and Controller Design of the Z-Source Inverter with Inductive Load

This paper proposes an average model for the Z- source inverter with inductive load using state space averaging. Based on this model, a controller is designed using gain scheduling by continuously varying the control gains according to the operating point. The average model is verified by simulation results. The validity of the controller is proved by experimental results.

[1]  Poh Chiang Loh,et al.  Modeling and design of multi-loop closed loop controller for Z-source inverter for Distributed Generation , 2006 .

[2]  Hua Li,et al.  A novel low frequency electronic ballast for HID lamps , 2004, Conference Record of the 2004 IEEE Industry Applications Conference, 2004. 39th IAS Annual Meeting..

[3]  P.C. Loh,et al.  Transient modeling and analysis of pulse-width modulated Z-source inverter , 2005, Fourtieth IAS Annual Meeting. Conference Record of the 2005 Industry Applications Conference, 2005..

[4]  Jingbo Liu,et al.  A modified space vector PWM for Z-source inverter-modeling and design , 2005, 2005 International Conference on Electrical Machines and Systems.

[5]  Poh Chiang Loh,et al.  Small-signal and signal-flow-graph modeling of switched Z-source impedance network , 2005, IEEE Power Electronics Letters.

[6]  Zhaoming Qian,et al.  Maximum boost control of the Z-source inverter , 2004, PESC 2004.

[7]  Hong-Hee Lee,et al.  Algorithms for controlling both the DC boost and AC output voltage of the Z-source inverter , 2005, 31st Annual Conference of IEEE Industrial Electronics Society, 2005. IECON 2005..

[8]  Fang Zheng Peng.  Z-source inverter , 2002 .

[9]  Jin Wang,et al.  Constant boost control of the Z-source inverter to minimize current ripple and voltage stress , 2006, IEEE Transactions on Industry Applications.