Performance of a Sensitive Micromachined Accelerometer With an Electrostatically Suspended Proof Mass

A three-axis micromachined accelerometer with a proof mass suspended electrostatically in six degrees of freedom was designed and tested to evaluate its performance of this sensitive sensor for potential microgravity space applications. The device is based on a glass/silicon/glass bonding structure, fabricated by bulk micromachining process, and operated with force-balance technology. The motion of the proof mass with respect to each side is fully servo-controlled by capacitive position sensing and electrostatic force feedback. The design and simulation of multiaxis suspension control loops are presented based on the stiffness requirements for different full-scale ranges. The ground test of this sensitive accelerometer is facilitated by setting the vertical axis at a relatively high measurement range to counteract the one-g gravity, whereas the range in two lateral axes can be set as low as possible to achieve high sensitivity. Detailed experimental results of electrostatic suspension, threeaxis accelerometer, and its cross-axis sensitivity are presented with the device operated initially in an atmospheric environment. The preliminary test results of a prototype accelerometer show that a sensitivity up to 688.8 V/g and a noise density down to 3 μg/Hz1/2 can be achieved by setting an extremely low full-scale range of ±2.90 mg. The results also show that much different stiffness levels in the design of three-axis suspension is a major source of cross coupling effects in the prototype accelerometer.

[1]  M. Esashi,et al.  Electrostatically levitated spherical 3-axis accelerometer , 2002, Technical Digest. MEMS 2002 IEEE International Conference. Fifteenth IEEE International Conference on Micro Electro Mechanical Systems (Cat. No.02CH37266).

[2]  Pierre Touboul,et al.  Development status of the differential accelerometer for the MICROSCOPE mission , 2007 .

[3]  M. Esashi,et al.  Electrostatically Levitated Ring-Shaped Rotational-Gyro/Accelerometer , 2003 .

[4]  Pierre Touboul,et al.  Flight experience on CHAMP and GRACE with ultra-sensitive accelerometers and return for LISA , 2003 .

[5]  Fengtian Han,et al.  A sensitive three-axis micromachined accelerometer based on an electrostatically suspended proof mass , 2013, 2013 IEEE SENSORS.

[6]  S. Nakamura,et al.  MEMS inertial sensor toward higher accuracy & multi-axis sensing , 2005, IEEE Sensors, 2005..

[7]  C. Shearwood,et al.  Proposal for Micromachined Accelerometer, Based on a Contactless Suspension With Zero Spring Constant , 2012, IEEE Sensors Journal.

[8]  Michael Kraft,et al.  Modelling squeeze film effects in a MEMS accelerometer with a levitated proof mass , 2005 .

[10]  Fengtian Han,et al.  Experimental study of a variable-capacitance micromotor with electrostatic suspension , 2010 .

[11]  Rong Zhang,et al.  Capacitive Sensor Interface for an Electrostatically Levitated Micromotor , 2009, IEEE Transactions on Instrumentation and Measurement.

[12]  H. Tu,et al.  Performance measurements of an inertial sensor with a two-stage controlled torsion pendulum , 2010 .

[13]  Fengtian Han,et al.  Performance of an active electric bearing for rotary micromotors , 2011 .

[14]  E. Bellouard,et al.  Microscope—extreme stability requirements for femto-g measurements , 2008 .

[15]  Dongmei Li,et al.  Nonlinear compensation of active electrostatic bearings supporting a spherical rotor , 2005 .

[16]  Weiping Zhang,et al.  Design, Fabrication and Levitation Experiments of a Micromachined Electrostatically Suspended Six-Axis Accelerometer , 2011, Sensors.