The electromigration and reliability of VLSI metallization under temperature gradient conditions

A novel buried Ti-W self-heating layer structure has been proposed to generate a controlled temperature gradient along the metal stripe. The maximum temperature difference between the highest temperature point of two samples is about /spl plusmn/1.08/spl deg/C. A metal line resistance method was utilized to determine the temperature distribution on the metal line. A series of electromigration (EM) tests were performed at positive and negative temperature gradient stress conditions. The results indicate that the negative temperature gradient greatly improved the failure time of electromigration. The higher the temperature gradient is, the more the mean time to failure (MTF) is increased. When the temperature gradient is the same, the failure time of electromigration will increase with the current density increase.

[1]  P. Mortini,et al.  Current and temperature distribution impact on electromigration failure location in SWEAT structure , 1994, Proceedings of 1994 IEEE International Conference on Microelectronic Test Structures.

[2]  G. Shen,et al.  Temperature gradient impact on electromigration failure in VLSI metallization , 1998, Fourteenth Annual IEEE Semiconductor Thermal Measurement and Management Symposium (Cat. No.98CH36195).

[3]  J. Black.  Electromigration failure modes in aluminum metallization for semiconductor devices , 1969 .

[4]  C. A. Ross.  Stress and Electromigration in Thin Film Metallisation , 1991 .

[5]  J. R. Lloyd,et al.  The electromigration failure distribution: The fine‐line case , 1991 .

[6]  M. Sakimoto,et al.  Temperature measurement of Al metallization and the study of Black's model in high current density , 1995, Proceedings of 1995 IEEE International Reliability Physics Symposium.