An environment friendly and efficient lignite-fired power generation process based on a boiler with an open pulverizing system and the recovery of water from mill-exhaust

This paper advances a novel lignite-fired power generation process based on a OPSB (boiler with an open pulverizing system) and the recovery of water from mill-exhaust after the comprehensive analysis of the open pulverizing system used for high-moisture coals and heat/water recovery from boiler exhaust. Then, the thermal calculation method that applies to OPSB is presented based on heat and mass balance analyses of the boiler. Finally, an efficient unit applying the OPSB process is compared with a conventional 600 MW lignite-fired power unit, and the performance of the efficient unit is calculated and discussed in detail. The results show that the efficient unit not only yields a notable increase in the boiler's (2.6%) and the power plant's (1.3%) thermal efficiency but also provides a remarkable advantage in water recovery due to the mass of water vapor concentrated in mill-exhaust. In the efficient unit, the volume fraction of water vapor in mill-exhaust reaches 34%, the water reclaimed from mill-exhaust is so much that a lignite-fired power plant with zero water consumption can be expected, while the pollutant emissions can be reduced in proportion to the increase in boiler thermal efficiency.

[1]  Ying Wu,et al.  Application of a low pressure economizer for waste heat recovery from the exhaust flue gas in a 600 MW power plant , 2012 .

[2]  Ming Liu,et al.  Thermodynamic analysis of pre-drying methods for pre-dried lignite-fired power plant , 2013 .

[3]  Alan L. Chaffee,et al.  Assessment of the water quality produced from mechanical thermal expression processing of three Latrobe Valley lignites , 2006 .

[4]  Luis M. Romeo,et al.  Optimization of boiler cold-end and integration with the steam cycle in supercritical units , 2010 .

[5]  P. Grammelis,et al.  Experimental investigation on the combustion behaviour of pre-dried Greek lignite , 2009 .

[6]  Christian Bergins,et al.  Kinetics and mechanism during mechanical/thermal dewatering of lignite , 2003 .

[7]  Xiaojun Shi,et al.  An investigation of the performance of compact heat exchanger for latent heat recovery from exhaust flue gases , 2011 .

[8]  Yin Li-qun.  Lignite resources and utilization outlook in China , 2004 .

[9]  George Favas,et al.  Hydrothermal dewatering of lower rank coals. 1. Effects of process conditions on the properties of dried product , 2003 .

[10]  Sze Zheng Yong,et al.  Oxy-fuel combustion of pulverized coal: Characterization, fundamentals, stabilization and CFD modeling , 2012 .

[11]  X. Peng,et al.  Effects of water vapor condensation on the convection heat transfer of wet flue gas in a vertical tube , 2001 .

[12]  E. Kakaras,et al.  Computer simulation studies for the integration of an external dryer into a Greek lignite-fired power plant , 2002 .

[13]  Wei‐Cheng Wang,et al.  Laboratory investigation of drying process of Illinois coals , 2012 .

[14]  W. Fan,et al.  The effect of air staged combustion on NOx emissions in dried lignite combustion , 2012 .