Minimizing Operating Costs of Vapor Compression Equipment with Optimal Service Scheduling

Dynamic programming was used to obtain optimal service schedules and costs for cleaning the condensers and evaporators of air-conditioning equipment. Results were obtained for a range of service and energy costs, characteristic fouling times, and equipment sizes for a single building and location. Minimum operating costs were compared with regular service intervals (representative of current practice) and a strategy where service is only performed when a constraint is violated (e.g., a comfort violation). It was found that optimal service scheduling reduced lifetime operating costs by as much as a factor of two over regular service intervals, and by 50% when compared to constrained only service. For practical implementation, a simple near-optimal algorithm for estimating optimal service scheduling was developed that does not require on-line forecasting or numerical optimization and is easily implemented within a micro-controller. Over the wide range of cases tested, the near-optimal algorithm gave operati...

[1]  H. Cikanek.  Space shuttle main engine failure detection , 1986, IEEE Control Systems Magazine.

[2]  M. Yoshimura,et al.  Effective diagnosis methods for air-conditioning equipment in telecommunications buildings , 1989, Conference Proceedings., Eleventh International Telecommunications Energy Conference.

[3]  A. Rabl,et al.  Energy management systems as diagnostic tools for building managers and energy auditors , 1987 .

[4]  Todd Michael Rossi.  Detection, diagnosis, and evaluation of faults in vapor compression equipment , 1995 .

[5]  G. M. Kaler.  Expert system predicts service , 1988 .

[6]  George Kaler,et al.  Embedded Expert System Development for Monitoring Packaged HVAC Equipment , 1990 .

[7]  Michèle Basseville,et al.  Detecting changes in signals and systems - A survey , 1988, Autom..

[8]  Rahmat A. Shoureshi,et al.  Failure detection diagnostics for thermofluid systems , 1992 .

[9]  Walter C. Merrill,et al.  Fault diagnosis for the Space Shuttle main engine , 1992 .

[10]  Jan F. Kreider,et al.  A quasi-real-time expert system for commercial building HVAC diagnostics , 1989 .

[11]  Paul M. Frank,et al.  Fault diagnosis in dynamic systems using analytical and knowledge-based redundancy: A survey and some new results , 1990, Autom..

[12]  T. Kumamaru,et al.  A fault diagnosis system for district heating and cooling facilities , 1991, Proceedings IECON '91: 1991 International Conference on Industrial Electronics, Control and Instrumentation.

[13]  Alan S. Willsky,et al.  A survey of design methods for failure detection in dynamic systems , 1976, Autom..

[14]  R. Onken,et al.  Failure detection in signal processing and sensing in flight control systems , 1978, 1978 IEEE Conference on Decision and Control including the 17th Symposium on Adaptive Processes.

[15]  Shahriar Negahdaripour,et al.  An Innovation-Based Methodology for HVAC System Fault Detection , 1985 .

[16]  R. Bellman.  Dynamic programming. , 1957, Science.

[17]  Paul M. Frank,et al.  Fault Diagnosis in Dynamic Systems via State Estimation - a Survey , 1987 .

[18]  J. S. Haberl,et al.  The impact of AI technology within the HVAC industry , 1990 .

[19]  Kenji Yamada,et al.  Development of Refrigerant Monitoring System for Automotive Air-Conditioning System , 1992 .

[20]  A. K. S. Jardine,et al.  Maintenance, Replacement, and Reliability , 2021 .

[21]  J.J. Gertler,et al.  Survey of model-based failure detection and isolation in complex plants , 1988, IEEE Control Systems Magazine.

[22]  Rolf Isermann,et al.  Process fault detection based on modeling and estimation methods - A survey , 1984, Autom..

[23]  R. J. Patton,et al.  Parameter-Insensitive Technique for Aircraft Sensor Fault Analysis , 1987 .

[24]  Rahmat Shoureshi,et al.  A robust failure diagnostic system for thermofluid processes , 1992, Autom..