Monitoring of the curing process in precast concrete slabs: An experimental study

Abstract In this paper a methodology for the quality control of the curing process in precast concrete plants is presented by non-destructive testing techniques. This methodology consists on a remote monitoring system and a method to estimate the strength gain of the precast elements during the curing process. The remote monitoring system is based on Wireless Sensor Networks (WSN) provided with temperature, humidity and ultrasonic sensors. The compressive strength is estimated using two different procedures, one based on temperature and the other one on ultrasonic velocity measurements. Comparing the compressive strength estimations obtained using temperature and ultrasonic velocity measurements, the concrete quality during early ages of curing can be controlled, and arising problems can immediately be detected. This methodology was tested in three different precast concrete plants in Spain.

[1]  Cherif Amer-Yahia,et al.  Inspection of Insulated Concrete Form walls with Ground Penetrating Radar , 2012 .

[2]  Nicholas J. Carino,et al.  The Maturity Method: Theory and Application , 1984 .

[3]  D. Breysse,et al.  Nondestructive evaluation of concrete strength: An historical review and a new perspective by combining NDT methods , 2012 .

[4]  L. G. Ullate,et al.  Application of a Micromechanical Model of Three Phases to Estimating the Porosity of Mortar by Ultrasound , 2006 .

[5]  Surendra P. Shah,et al.  Green and early age compressive strength of extruded cement mortar monitored with compression tests and ultrasonic techniques , 2006 .

[6]  Jordi Payá,et al.  The use of electrical impedance spectroscopy for monitoring the hydration products of Portland cement mortars with high percentage of pozzolans , 2013 .

[7]  Nicholas J. Carino,et al.  The Maturity Method: From Theory to Application , 2001 .

[8]  A. Ramezanianpour,et al.  Effect of steam curing cycles on strength and durability of SCC: A case study in precast concrete , 2013 .

[9]  C. Grosse,et al.  Measuring the change in ultrasonic p-wave energy transmitted in fresh mortar with additives to monitor the setting , 2009 .

[10]  F. Puertas,et al.  The effect of curing temperature on sulphate-resistant cement hydration and strength , 2008 .

[11]  Chi Sun Poon,et al.  Characterization of concrete properties from dielectric properties using ground penetrating radar , 2009 .

[12]  Goran Turk,et al.  Comparison between two ultrasonic methods in their ability to monitor the setting process of cement pastes , 2009 .

[13]  Ignacio Segura,et al.  Assessment of mortar evolution in pig slurry by mechanical and ultrasonic measurements , 2010 .

[14]  Matija Gams,et al.  Recent advances of ultrasonic testing of cement based materials at early ages. , 2014, Ultrasonics.

[15]  H. Reinhardt,et al.  Continuous monitoring of setting and hardening of mortar and concrete , 2004 .

[16]  Cristina Vázquez-Herrero,et al.  A new procedure to ensure structural safety based on the maturity method and limit state theory , 2012 .

[17]  Torben Knudsen,et al.  The dispersion model for hydration of portland cement I. General concepts , 1984 .

[18]  Martine Wevers,et al.  Active and passive monitoring of the early hydration process in concrete using linear and nonlinear acoustics , 2009 .