A multilevel calculation scheme for risk-based robustness quantification of reinforced concrete frames

Abstract Structural robustness has become an important research topic in the engineering community since several large failures in the past decades led to the public awareness and indicated the importance to consider structural robustness during the structural design. So far most research has been focusing on structural measures to improve structural robustness and on theoretical methods to quantify structural robustness. However with respect to the analysis of concrete frames, there are only a limited number of examples which try to quantify the achieved robustness level for the available structural measures, such as the development of alternate load paths by membrane action. In this paper both advanced calculation methods and quantification approaches for robustness are combined by a computational efficient calculation scheme which considers different levels of structural idealisation. The developed approach is able to quantify the reliability and structural robustness of planar reinforced concrete frames in an objective way while using a conditional risk-based robustness index and taking into account the developed membrane action. As an illustration the developed calculation scheme is applied and discussed for two alternative designs of a regular office building. The results show the importance of the uncertainty on membrane action effects on the structure in case of an unforeseeable event leading to a notional column removal.

[1]  Kang Hai Tan,et al.  Experimental and numerical investigation on progressive collapse resistance of reinforced concrete beam column sub-assemblages , 2013 .

[2]  Robby Caspeele,et al.  Experimental investigation of the load-displacement behaviour under catenary action in a restrained reinforced concrete slab strip , 2013 .

[3]  Jinkoo Kim,et al.  Progressive collapse-resisting capacity of RC beam–column sub-assemblage , 2011 .

[4]  Alfred Strauss,et al.  Stochastic fracture‐mechanical parameters for the performance‐based design of concrete structures , 2014 .

[5]  Edward J. Rhomberg,et al.  Membrane Action in Partially Restrained Slabs , 1988 .

[6]  Kang Hai Tan,et al.  Robustness Assessment of Exterior Precast Concrete Frames under Column Removal Scenarios , 2016 .

[7]  Kang Hai Tan,et al.  Structural Behavior of RC Beam-Column Subassemblages under a Middle Column Removal Scenario , 2013 .

[8]  Xinzheng Lu,et al.  Progressive Collapse Resistance Demand of RC Frames under Catenary Mechanism , 2014 .

[9]  Colin Bailey,et al.  Membrane action of unrestrained lightly reinforced concrete slabs at large displacements , 2001 .

[10]  Uwe Starossek,et al.  Approaches to measures of structural robustness , 2011 .

[11]  Bernt J. Leira,et al.  Application of Probabilistic Robustness Framework: Risk Assessment of Multi-Storey Buildings under Extreme Loading , 2012 .

[12]  Jean-Pierre Jaspart,et al.  Experimental test simulating a column loss in a composite frame , 2010 .

[13]  Dimos C. Charmpis,et al.  The cost of satisfying design requirements on progressive collapse resistance – Investigation based on structural optimisation , 2016 .

[14]  Giorgio Monti,et al.  Yield and Ultimate Moment and Curvature Closed-Form Equations for Reinforced Concrete Sections , 2015 .

[15]  Eduardo Cavaco,et al.  Robustness of corroded reinforced concrete structures – a structural performance approach , 2010 .

[16]  Bing Li,et al.  Experimental and Analytical Assessment on RC Interior Beam-Column Subassemblages for Progressive Collapse , 2012 .

[17]  Dan Dubina,et al.  Improving the structural robustness of multi-story steel-frame buildings , 2015 .

[18]  Mohammed Ettouney,et al.  Loss-of-stability induced progressive collapse modes in 3D steel moment frames , 2015 .

[19]  A. Y. Elghazouli,et al.  REALISTIC MODELING OF COMPOSITE AND REINFORCED CONCRETE FLOOR SLABS UNDER EXTREME LOADING. II: VERIFICATION AND APPLICATION , 2004 .

[20]  Kai Qian,et al.  Uncertainty and Sensitivity Analysis of Reinforced Concrete Frame Structures Subjected to Column Loss , 2017 .

[21]  Haresh C. Shah,et al.  Engineering role in failure cost evaluation for buildings , 1997 .

[22]  R. Park.  Tensile membrane behaviour of uniformly loaded rectangular reinforced concrete slabs with fully restrained edges , 1964 .

[23]  Wouter Botte,et al.  Influence of Design Parameters on Tensile Membrane Action in Reinforced Concrete Slabs , 2015 .

[24]  Bassam A. Izzuddin,et al.  REALISTIC MODELING OF COMPOSITE AND REINFORCED CONCRETE FLOOR SLABS UNDER EXTREME LOADING. I: ANALYTICAL METHOD , 2004 .

[25]  David A. Nethercot,et al.  Progressive collapse of multi-storey buildings due to sudden column loss — Part I: Simplified assessment framework , 2008 .

[26]  Jack W. Baker,et al.  On the assessment of robustness , 2008 .

[27]  Youpo Su,et al.  Progressive Collapse Resistance of Axially-Restrained Frame Beams , 2009 .

[28]  Colin Bailey,et al.  Membrane action of slab/beam composite floor systems in fire , 2004 .

[29]  Ian Burgess,et al.  Experimental behaviour of concrete floor slabs at large displacements , 2004 .

[30]  Borja Herraiz,et al.  Novel design approach for the analysis of laterally unrestrained reinforced concrete slabs considering membrane action , 2016 .

[31]  Guoqing Xu,et al.  Probabilistic Robustness Assessment of Pre-Northridge Steel Moment Resisting Frames , 2011 .

[32]  Miroslav Sykora,et al.  Robustness of Structures: Lessons from Failures , 2012 .

[33]  Dan M. Frangopol,et al.  Life-cycle performance, management, and optimisation of structural systems under uncertainty: accomplishments and challenges 1 , 2011, Structures and Infrastructure Systems.

[34]  Christian Bucher,et al.  Robustness analysis in structural optimization , 2009 .

[35]  F. J. Vecchio,et al.  Membrane action in reinforced concrete slabs , 1990 .

[36]  A. Olsson,et al.  On Latin hypercube sampling for structural reliability analysis , 2003 .