Development of a Particulate Filter Model for the Prediction of Backpressure: Improved Momentum Balance and Entrance and Exit Effect Equations
暂无分享,去创建一个
Timothy C. Watling | Maya R. Ravenscroft | Jason P.E. Cleeton | Ian D. Rees | David A.R. Wilkins | Ian D. Rees | J. Cleeton | T. Watling | I. Rees | David A.R. Wilkins
[1] Edward J. Bissett,et al. Mathematical model of the thermal regeneration of a wall-flow monolith diesel particulate filter , 1984 .
[2] Lawrence F. Shampine,et al. The MATLAB ODE Suite , 1997, SIAM J. Sci. Comput..
[3] Farhang Shadman,et al. Thermal regeneration of diesel-particulate monolithic filters , 1985 .
[4] Dennis N. Assanis,et al. Simulating Area Conservation and the Gas-Wall Interface for One-Dimensional Based Diesel Particulate Filter Models , 2008 .
[5] S. Whitaker. Flow in porous media I: A theoretical derivation of Darcy's law , 1986 .
[6] Achim Karl-Erich Heibel,et al. Predicting Pressure Drop of Wall-Flow Diesel Particulate Filters - Theory and Experiment , 2000 .
[7] Jeffrey C. Lagarias,et al. Convergence Properties of the Nelder-Mead Simplex Method in Low Dimensions , 1998, SIAM J. Optim..
[8] J. Tollefson. Soot a major contributor to climate change , 2013, Nature.
[9] J. S. Wyler,et al. Generalized Flow Across an Abrupt Enlargement , 1976 .
[10] Nazeer Ahmed,et al. Nonlinear Flow in Porous Media , 1969 .
[11] S. Whitaker. The Forchheimer equation: A theoretical development , 1996 .
[12] S. G. Penoncello,et al. Thermodynamic Properties of Air and Mixtures of Nitrogen, Argon, and Oxygen From 60 to 2000 K at Pressures to 2000 MPa , 2000 .
[13] Maya R. Ravenscroft,et al. Development, validation and application of a model for an SCR catalyst coated diesel particulate filter , 2012 .
[14] Johann C. Wurzenberger,et al. Advanced Simulation Technologies for Diesel Particulate Filters, A Fundamental Study on Asymmetric Channel Geometries , 2007 .
[15] D. Chatterjee,et al. Perspectives of the Automotive Industry on the Modeling of Exhaust Gas Aftertreatment Catalysts , 2011 .
[16] A. L. London,et al. Laminar Flow Forced Convection Heat Transfer and Flow Friction in Straight and Curved Ducts - A Summary of Analytical Solutions , 1971 .
[17] B. Maletic,et al. Interaction of NOx Reduction and Soot Oxidation in a DPF with Cu-Zeolite SCR Coating , 2015, Emission Control Science and Technology.
[18] Biagio Ciuffo,et al. Development of the World-wide harmonized Light duty Test Cycle (WLTC) and a possible pathway for its introduction in the European legislation , 2015 .
[19] Grigorios C. Koltsakis,et al. Intra-layer temperature gradients during regeneration of diesel particulate filters , 2002 .
[20] Athanasios G. Konstandopoulos,et al. Flow Resistance Descriptors for Diesel Particulate Filters: Definitions, Measurements and Testing , 2003 .
[21] Margaritis Kostoglou,et al. Frictional and heat transfer characteristics of flow in square porous tubes of wall-flow monoliths , 2012 .
[22] P. Hawker,et al. Effect of a Continuously Regenerating Diesel Particulate Filter on Non-Regulated Emissions and Particle Size Distribution , 1998 .
[23] Akira Nagashima,et al. Viscosity and thermal conductivity of dry air in the gaseous phase , 1985 .
[24] R. Niessner. The many faces of soot: characterization of soot nanoparticles produced by engines. , 2014, Angewandte Chemie.
[25] M. Kostoglou,et al. Fundamental Studies of Diesel Particulate Filters: Transient Loading, Regeneration and Aging , 2000 .
[26] Ronny Allansson,et al. Optimized Filter Design and Selection Criteria for Continuously Regenerating Diesel Particulate Traps , 1999 .
[27] Lawrence F. Shampine,et al. A BVP solver based on residual control and the Maltab PSE , 2001, TOMS.
[28] Grigorios C. Koltsakis,et al. Catalyzed diesel particulate filter modeling , 2013 .
[29] S. M. Ghiaasiaan,et al. Pressure drop caused by abrupt flow area changes in small channels , 2005 .
[30] Song-Lin Yang,et al. An Advanced 1D 2-Layer Catalyzed Diesel Particulate Filter Model to Simulate: Filtration by the Wa , 2006 .
[31] Zissis Samaras,et al. Diesel particulate filter pressure drop Part 1: Modelling and experimental validation , 2004 .
[32] Martin Votsmeier,et al. An experimental and simulation study on the cold start behaviour of particulate filters with wall integrated three way catalyst , 2014 .
[33] Zhen Huang,et al. Review of the state-of-the-art of exhaust particulate filter technology in internal combustion engines. , 2015, Journal of environmental management.
[34] Stephen Whitaker,et al. ADVANCES IN THEORY OF FLUID MOTION IN POROUS MEDIA , 1969 .
[35] A. Briot,et al. One Dimensional Backpressure Model for Asymmetrical Cells DPF , 2007 .
[36] D. Kittelson. Engines and nanoparticles: a review , 1998 .
[37] Jacob A. Moulijn,et al. Structured Catalysts and Reactors , 2005 .
[38] Platinum Group Metal and Washcoat Chemistry Effects on Coated Gasoline Particulate Filter Design , 2015 .
[39] Margaritis Kostoglou,et al. Progress in Diesel Particulate Filter Simulation , 2005 .
[40] E. J. Bissett,et al. Improved Transfer Coefficients for Wall-Flow Monolithic Catalytic Reactors: Energy and Momentum Transport , 2012 .
[41] T. Johnson. Vehicular Emissions in Review , 2012 .
[42] Ali Keskin,et al. The pollutant emissions from diesel-engine vehicles and exhaust aftertreatment systems , 2014, Clean Technologies and Environmental Policy.
[43] Edward J. Bissett,et al. Thermal regeneration of particle filters with large conduction , 1985 .
[44] T. Johnson. Diesel Engine Emissions and Their Control , 2008 .
[45] Petr Kočí,et al. Modelling of diesel filters for particulates removal , 2009 .
[46] Athanasios G. Konstandopoulos,et al. Inertial Contributions to the Pressure Drop of Diesel Particulate Filters , 2001 .