Differential Fringe-Field MEMS Accelerometer

A new differential microelectromechanical systems accelerometer based on fringe-field sensing is presented. The basic working principle relies on the generation of fringe electric fields in the volume in between and over two biased coplanar interconnections; a grounded suspended micromachined mass, moving in this fringe volume, differently intercepts the electric field lines for different positions, giving rise to capacitance changes between the interconnections, used as electrodes. The capacitance variation can be then transformed into a voltage signal using standard capacitive readout techniques. The design exploits a new geometry, a technological scaling, and for the first time, a differential configuration to reach a measured sensitivity of 2.7 fF/g in the tested range of ±2 g of external acceleration. With respect to parallel-plate configurations, the device is immune from in-plane pull-in instability as the suspended mass does not face fixed parts biased at different voltages.

[1]  G. Barbastathis,et al.  Dynamic pull-in of parallel-plate and torsional electrostatic MEMS actuators , 2005, Journal of Microelectromechanical Systems.

[2]  Peter Gumbsch,et al.  High-cycle fatigue and strengthening in polycrystalline silicon , 2008 .

[3]  C Schroder,et al.  Combined MEMS inertial sensors for IMU applications , 2010, 2010 IEEE 23rd International Conference on Micro Electro Mechanical Systems (MEMS).

[4]  Yu-Chong Tai,et al.  Development of surface micromachinable capacitive accelerometer using fringe electrical field , 2003, TRANSDUCERS '03. 12th International Conference on Solid-State Sensors, Actuators and Microsystems. Digest of Technical Papers (Cat. No.03TH8664).

[5]  Ernesto Lasalandra,et al.  Readout of MEMS capacitive sensors beyond the condition of pull-in instability , 2011 .

[6]  B. Boser,et al.  Surface micromachined accelerometers , 1995, Proceedings of the IEEE 1995 Custom Integrated Circuits Conference.

[7]  J. Wu,et al.  Hewlett packard's seismic grade MEMS accelerometer , 2011, 2011 IEEE 24th International Conference on Micro Electro Mechanical Systems.

[8]  Bernhard E. Boser,et al.  Charge control of parallel-plate, electrostatic actuators and the tip-in instability , 2003 .

[9]  Bernhard E. Boser,et al.  A three-axis micromachined accelerometer with a CMOS position-sense interface and digital offset-trim electronics , 1999, IEEE J. Solid State Circuits.

[10]  G. Jourdan,et al.  M&NEMS: A new approach for ultra-low cost 3D inertial sensor , 2009, 2009 IEEE Sensors.

[11]  Alberto Corigliano,et al.  A Resonant Microaccelerometer With High Sensitivity Operating in an Oscillating Circuit , 2010, Journal of Microelectromechanical Systems.

[12]  G Langfelder,et al.  MEMS Motion Sensors Based on the Variations of the Fringe Capacitances , 2011, IEEE Sensors Journal.

[13]  Bernhard E. Boser,et al.  A 3-axis force balanced accelerometer using a single proof-mass , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[14]  Giacomo Langfelder,et al.  Low-noise real-time measurement of the position of movable structures in MEMS , 2008 .