TABLASER: trace (element) analyzer based on laser ablation and selectively excited radiation.

Trace element analysis based on laser ablation and selectively excited radiation (TABLASER) is proposed as a new and reliable microultratrace technique for quantitative in situ element analysis. Measurements of trace quantities of chromium in samples of NBS standard reference steel, doped skim milk powder, and doped flour have been undertaken. A linear 45 degrees slope dependence of signal vs concentration that extends beyond 1% in the case of chromium was observed. Although the present sensitivity limit is in the ppm range, improved overlap between the probing dye laser beam and the wave of atomized material combined with a better design of the optical system could reduce the detection limit of the TABLASER to the ppb range. This would correspond to an absolute detection limit of about 10(-16) g. An important feature of this new technique is its relative freedom from chemical matrix effects, which suggests the possibility of a universal calibration curve for all elements irrespective of the substrate matrix in which they are contained. This technique is also adaptable to multielement analysis.

[1]  James D. Winefordner,et al.  Improvement of detection limits in laser-excited atomic fluorescence flame spectrometry , 1978 .

[2]  R. Measures,et al.  Atomic lifetime measurements obtained by the use of laser ablation and selective excitation spectroscopy , 1977 .

[3]  D. C. McDonald.  Use of internal standards for atomic absorption spectrometric analyses of samples atomized by sputtering , 1977 .

[4]  H. Sunahara,et al.  Laser-vaporized atomic absorption spectrometry of solid samples , 1977 .

[5]  J. Wessel,et al.  Saturated optical nonresonant emission spectroscopy (SONRES) for atomic detection , 1977 .

[6]  J. Hohimer,et al.  Picogram detection of cesium in aqueous solution by nonflame atomic fluorescence spectroscopy with dye laser excitation , 1977 .

[7]  J. Daily,et al.  Saturation effects in laser induced fluorescence spectroscopy. , 1977, Applied optics.

[8]  F. Hillenkamp,et al.  A high-sensitivity laser microprobe mass analyzer , 1975 .

[9]  A. Schawlow,et al.  Absolute measurement of very low sodium-vapor densities using laser resonance fluorescence* , 1975 .

[10]  E. Piepmeier,et al.  Atomic Absorption Measurements in a Q-Switched Laser Plume Using Pulsed Hollow Cathode Lamps , 1973 .

[11]  E. Piepmeier,et al.  Atmospheric Influences on Q-Switched Laser Sampling and Resulting Plumes , 1971 .

[12]  W. J. Treytl,et al.  Effect of matrix material on laser-induced elemental spectral emission , 1970 .

[13]  H. V. Malmstadt,et al.  Q-Switched laser energy absorption in the plume of an aluminum alloy , 1969 .

[14]  R. Measures.  Selective Excitation Spectroscopy and Some Possible Applications , 1968 .

[15]  A. Whitehead,et al.  Laser-Spark Excitation of Homogeneous Powdered Materials , 1968 .

[16]  F. Martini,et al.  Photomultiplier gate for stimulated-spontaneous light scattering discrimination. , 1967 .

[17]  R. Minck,et al.  Spectrochemical analysis using a pulsed laser source , 1964 .

[18]  D. H. Dieke.  Session 15. Intensities and Transition Probabilities , 1962 .

[19]  Y. Kawasumi,et al.  RESEARCH NOTES: Expansion of a laser produced plasma into a vacuum , 1971 .