Effects of deposition temperature on the mechanical and structural properties of amorphous Al-Si-O thin films prepared by RF magnetron sputtering

Aluminosilicate (Al-Si-O) thin films containing up to 31 at. % Al and 23 at. % Si were prepared by reactive RF magnetron co-sputtering. Mechanical and structural properties were measured by indentation and specular reflectance infrared spectroscopy at varying Si sputtering target power and substrate temperature in the range 100 to 500 {\deg}C. It was found that an increased substrate temperature and Al/Si ratio give denser structure and consequently higher hardness (7.4 to 9.5 GPa) and reduced elastic modulus (85 to 93 GPa) while at the same time lower crack resistance (2.6 to 0.9 N). The intensity of the infrared Si-O-Si/Al asymmetric stretching vibrations shows a linear dependence with respect to Al concentration. The Al-O-Al vibrational band (at 1050 cm-1) shifts towards higher wavenumbers with increasing Al concentration which indicates a decrease of the bond length, evidencing denser structure and higher residual stress, which is supported by the increased hardness. The same Al-O-Al vibrational band (at 1050 cm-1) shifts towards lower wavenumber with increasing substrate temperature indicating an increase in the of the average coordination number of Al.

[1]  M. Edén Probing oxide-based glass structures by solid-state NMR: Opportunities and limitations , 2023, Journal of Magnetic Resonance Open.

[2]  R. Youngman,et al.  Phase separation in mullite-composition glass , 2022, Scientific Reports.

[3]  Sharafat Ali,et al.  Composition‐structure‐property relationships of transparent Ca−Al−Si−O−N oxynitride glasses: The roles of nitrogen and aluminium , 2022, Journal of the American Ceramic Society.

[4]  Sharafat Ali,et al.  Mechanical, thermal, and structural investigations of chemically strengthened Na2O–CaO–Al2O3–SiO2 glasses , 2022, Frontiers in Materials.

[5]  S. Yoshida,et al.  Indentation and abrasion in glass products: Lessons learned and yet to be learned , 2021, International Journal of Applied Glass Science.

[6]  M. Smedskjaer,et al.  Advancing the Mechanical Performance of Glasses: Perspectives and Challenges , 2021, Advanced materials.

[7]  M. Smedskjaer,et al.  Vibrational disorder and densification-induced homogenization of local elasticity in silicate glasses , 2021, Scientific Reports.

[8]  Yen‐Ting Lin,et al.  Vibrational spectroscopy analysis of silica and silicate glass networks , 2021, Journal of the American Ceramic Society.

[9]  Liping Huang,et al.  Towards damage resistant Al2O3–SiO2 glasses with structural and chemical heterogeneities through consolidation of glassy nanoparticles , 2021 .

[10]  Sharafat Ali,et al.  Preparation and tunable optical properties of amorphous AlSiO thin films , 2021 .

[11]  P. Eklund,et al.  An upgraded ultra-high vacuum magnetron-sputtering system for high-versatility and software-controlled deposition , 2020, Vacuum.

[12]  Stefan Karlsson,et al.  Towards improved cover glasses for photovoltaic devices , 2020, Progress in Photovoltaics: Research and Applications.

[13]  H. Inoue,et al.  Real-Space Mapping of Oxygen Coordination in Phase-Separated Aluminosilicate Glass: Implication for Glass Stability , 2020 .

[14]  N. Shapkin,et al.  Relationship between the Tribotechnical Characteristics and the Physical and Chemical Properties of Aluminosilicates and Their Composites , 2020 .

[15]  E. Levänen,et al.  Highly ductile amorphous oxide at room temperature and high strain rate , 2019, Science.

[16]  Yip-Wah Chung,et al.  Commentary on using H/E and H/E as proxies for fracture toughness of hard coatings , 2019, Thin Solid Films.

[17]  L. Österlund,et al.  Transparent TiO2 and ZnO Thin Films on Glass for UV Protection of PV Modules , 2019, Front. Mater..

[18]  Sharafat Ali,et al.  Optical and mechanical properties of amorphous Mg-Si-O-N thin films deposited by reactive magnetron sputtering , 2019, Surface and Coatings Technology.

[19]  Navid Namdari,et al.  On Coating Techniques for Surface Protection: A Review , 2019, Journal of Manufacturing and Materials Processing.

[20]  R. Orman,et al.  Simultaneous chemical vapor deposition and thermal strengthening of glass , 2019, Thin Solid Films.

[21]  M. Srinivasan,et al.  Amorphous Vanadium Oxide Thin Films as Stable Performing Cathodes of Lithium and Sodium-Ion Batteries , 2018, Nanoscale Research Letters.

[22]  M. Smedskjaer,et al.  Time and humidity dependence of indentation cracking in aluminosilicate glasses , 2018, Journal of Non-Crystalline Solids.

[23]  T. Roch,et al.  Effect of deposition conditions on physical properties of sputtered silicon oxynitride thin films on float glass , 2018 .

[24]  J. Garden,et al.  Boson peak, heterogeneity and intermediate-range order in binary SiO2-Al2O3 glasses , 2018, Scientific Reports.

[25]  K. Bange,et al.  Mechanical and optical properties of SiO2 thin films deposited on glass , 2018, Chemical Papers.

[26]  Morten Mattrup Smedskjær,et al.  Discovery of Ultra-Crack-Resistant Oxide Glasses with Adaptive Networks , 2017 .

[27]  N. Hong,et al.  Insight into dynamics and microstructure of aluminum-silicate melts from molecular dynamics simulation , 2017 .

[28]  E. Broitman,et al.  Synthesis and characterization of the mechanical and optical properties of Ca-Si-O-N thin films deposited by RF magnetron sputtering , 2017 .

[29]  M. Huvé,et al.  Aluminosilicate glass thin films elaborated by pulsed laser deposition , 2017 .

[30]  E. Broitman Indentation Hardness Measurements at Macro-, Micro-, and Nanoscale: A Critical Overview , 2017, Tribology Letters.

[31]  B. Aitchison,et al.  Corrosion Resistance of Atomic Layer Deposition-Generated Amorphous Thin Films. , 2016, ACS applied materials & interfaces.

[32]  E. Broitman,et al.  Novel transparent MgSiON thin films with high hardness and refractive index , 2016 .

[33]  Hiroyuki Inoue,et al.  Crack-resistant Al2O3–SiO2 glasses , 2016, Scientific Reports.

[34]  Xiaofang Zhang,et al.  Nanoindentation Study of the Surface of Ion-Exchanged Lithium Silicate Glass , 2016 .

[35]  Didier Chicot,et al.  Work-of-indentation coupled to contact stiffness for calculating elastic modulus by instrumented indentation , 2016 .

[36]  A. Adamczyk The structural studies of aluminosilicate gels and thin films synthesized by the sol-gel method using different Al2O3 and SiO2 precursors , 2015 .

[37]  R. Almeida,et al.  Raman Spectroscopy of Glasses , 2015 .

[38]  K. Simon,et al.  A 2000-year perspective on indentation crack resistance and brittleness of glass , 2015 .

[39]  B. Sturtevant,et al.  Properties of amorphous SiAlON thin films grown by RF magnetron co-sputtering , 2014 .

[40]  H. Eckert,et al.  Medium-Range Order in Sol–Gel Prepared Al2O3–SiO2 Glasses: New Results from Solid-State NMR , 2014 .

[41]  R. Snyders,et al.  Deposition of cerium oxide thin films by reactive magnetron sputtering for the development of corrosion protective coatings , 2013 .

[42]  T. Theophanides Infrared Spectroscopy - Materials Science, Engineering and Technology , 2012 .

[43]  L. Escobar-Alarcón,et al.  Amorphous niobium oxide thin films , 2010 .

[44]  S. Yoshida,et al.  Effect of densification on crack initiation under Vickers indentation test , 2010 .

[45]  P. Vitanov,et al.  Chemical deposition of Al2O3 thin films on Si substrates , 2009 .

[46]  T. Kunitake,et al.  Size-scaling of proton conductivity in amorphous aluminosilicate acid thin films. , 2009, Journal of the American Chemical Society.

[47]  Matteo Ciccotti,et al.  Stress-corrosion mechanisms in silicate glasses , 2009, 0901.2809.

[48]  H. Kahn,et al.  Fracture Toughness, Fracture Strength, and Stress Corrosion Cracking of Silicon Dioxide Thin Films , 2008, Journal of Microelectromechanical Systems.

[49]  Corinne Champeaux,et al.  Properties of aluminum oxide thin films deposited by pulsed laser deposition and plasma enhanced chemical vapor deposition , 2008 .

[50]  T. Perova,et al.  Investigation of alumina–silica films deposited by pulsed injection metal–organic chemical vapour deposition , 2006 .

[51]  M. Sierka,et al.  Synthesis and structure of ultrathin aluminosilicate films. , 2006, Angewandte Chemie.

[52]  T. Hübert,et al.  Wear resistant alumina coatings produced by a sol–gel process , 2006 .

[53]  Hartmut Schneider,et al.  Structure of SiO2–Al2O3 glasses: Combined X-ray diffraction, IR and Raman studies , 2005 .

[54]  D. Meyer,et al.  Preparation of aluminosilicate crystalline coatings from sol‐gel derived alumina films deposited on silicon/silica substrates , 2005 .

[55]  S. Sen,et al.  High-Resolution Multinuclear NMR Structural Study of Binary Aluminosilicate and Other Related Glasses , 2004 .

[56]  S. Lau,et al.  Properties of amorphous ZrOx thin films deposited by filtered cathodic vacuum arc , 2003 .

[57]  D. Kuo,et al.  Amorphous aluminum silicate films by metal-organic chemical vapor deposition using aluminum-tri-sec-butoxide and tetraethyl orthosilicate , 2003 .

[58]  J. Musil,et al.  Relationships between hardness, Young's modulus and elastic recovery in hard nanocomposite coatings , 2002 .

[59]  L. Stoch,et al.  Infrared spectroscopy in the investigation of oxide glasses structure , 1999 .

[60]  O. Zywitzki,et al.  Effect of the substrate temperature on the structure and properties of Al2O3 layers reactively deposited by pulsed magnetron sputtering , 1996 .

[61]  G. Favero,et al.  The distribution of aluminium in the earth: from cosmogenesis to Sial evolution , 1996 .

[62]  V. Haanappel,et al.  Properties of alumina films prepared by atmospheric pressure metal-organic chemical vapour deposition , 1995 .

[63]  B. Ohtani,et al.  Electrochromism of Niobium Oxide Thin Films Prepared by the Sol‐Gel Process , 1994 .

[64]  W. Mozgawa,et al.  Vibrational spectroscopy of the amorphous silicates , 1993 .

[65]  Jason T. Yustein,et al.  Reactions of pulsed-laser evaporated aluminum atoms with oxygen: infrared spectra of the reaction products in solid argon , 1992 .

[66]  G. Pharr,et al.  An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experiments , 1992 .

[67]  J. Stebbins NMR evidence for five-coordinated silicon in a silicate glass at atmospheric pressure , 1991, Nature.

[68]  D. Rickerby,et al.  The mechanical properties of wear-resistant coatings: II: Experimental studies and interpretation of hardness , 1987 .

[69]  J. Williams,et al.  Preparation of Thin Mullite Films , 1963 .

[70]  L. Cormier Glasses: Aluminosilicates , 2021, Encyclopedia of Materials: Technical Ceramics and Glasses.

[71]  Encyclopedia of Materials: Technical Ceramics and Glasses , 2021 .

[72]  H. Doweidar Structural considerations on Al 2 O 3 –SiO 2 and derived glasses , 2018 .

[73]  J. Míguez,et al.  On the Physical Vapour Deposition (PVD): Evolution of Magnetron Sputtering Processes for Industrial Applications , 2018 .

[74]  T. Sugino,et al.  Characterization of Si-added aluminum oxide (AlSiO) films for power devices , 2010 .

[75]  H. Arzate,et al.  Biocompatibility and bio-corrosion resistance of amorphous oxide thin films , 2009 .

[76]  WerrBn LonwnNsrBrN,et al.  THE DISTRIBUTION OF ALUMINUM IN THE TETRAHEDRA OF SILICATES AND ALUMINATES , 2007 .

[77]  E. Bourhis,et al.  Characterisation of TiC x O y thin films produced by PVD techniques , 2007 .

[78]  J. Pinkas CHEMISTRY OF SILICATES AND ALUMINOSILICATES , 2005 .

[79]  Wen-Cheng J. Wei,et al.  Formation of mullite thin film via a sol-gel process with polyvinylpyrrolidone additive , 2001 .

[80]  A. Barron,et al.  Chemical vapour deposition of aluminium silicate thin films , 1991 .

[81]  F. G. Peters,et al.  Preparation of Oxide Glass Films by Reactive Sputtering , 1963 .