This paper presents experimental results for a new condition monitoring system that uses a combination of piezoelectric and fibre-optic technologies as the active and passive elements respectively. Composite plate samples have been manufactured containing two groups of optical-fibres (typically four strands per group) embedded across the length of the plate. Polyimide coated 4/125 /spl mu/m single-mode glass fibre has been utilised and connected to a portable 633 nm Mach-Zehnder fibre interferometer for signal demodulation and subsequent data acquisition. For this present work, 1-3 connectivity piezocomposite transducers have been used to generate a known Lamb wave within carbon fibre reinforced composite plate (CFRP) structures. The S/sub 0/ mode was selected due to the relatively large in-plane motion and low dispersion characteristics. Results using both externally surface bonded fibres and embedded fibres are presented, for a range of defective plates. Defects ranging from 1 mm diameter holes through to significant delaminations have been detected at an ultrasonic operating frequency of 285 kHz.
[1]
I. A. Viktorov.
Rayleigh and Lamb Waves
,
1967
.
[2]
J. Hossack,et al.
Finite-element analysis of 1-3 composite transducers
,
1991,
IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.
[3]
P. Cawley,et al.
The interaction of Lamb waves with delaminations in composite laminates
,
1993
.
[4]
G. Hayward,et al.
Assessing the influence of pillar aspect ratio on the behavior of 1-3 connectivity composite transducers
,
1996,
IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control.
[5]
G. Hayward,et al.
Real-time ultrasonic techniques suitable for implementing non-contact NDT systems employing piezoceramic composite transducers
,
1994
.
[6]
D. Jackson.
Monomode optical fibre interferometers for precision measurement
,
1985
.