Computation of the mass transfer coefficient of FCC particles in a thin bubbling fluidized bed using two- and three-dimensional CFD simulations

Abstract In this study, the standard kinetic theory based model with a modified drag correlation was successfully used to compute the mass transfer coefficients and the Sherwood numbers of FCC particles in a thin bubbling fluidized bed column using the additive diffusional and chemical reaction resistances concept. Also, the effects of the computational domain (two- or three-dimensional) and the reaction rate constant (low and high) are discussed. The computations show that the Sherwood numbers are in agreement with the measurement ranges for small particles in the fluidized bed system. The mass transfer coefficients and the Sherwood numbers are high near the inlet section, and decrease to a constant value with increasing height in the column. The two-dimensional computational domain simulations provide enough information to explain the phenomena inside a symmetrical system, but three-dimensional computational domain simulations are still needed for asymmetrical systems. Finally, the mass transfer coefficients and the Sherwood numbers increased with the larger reaction rate constant.

[1]  Gerald M. Colver.  The effect of van der Waals and charge induced forces on bed modulus of elasticity in ac/dc electrofluidized beds of fine powders¿a unified theory , 2006 .

[2]  Gregory G. Hendrickson.  Electrostatics and gas phase fluidized bed polymerization reactor wall sheeting , 2006 .

[3]  D. Gidaspow.  Multiphase Flow and Fluidization: Continuum and Kinetic Theory Descriptions , 1994 .

[4]  Pornpote Piumsomboon,et al.  Two- and three-dimensional CFD modeling of Geldart A particles in a thin bubbling fluidized bed: Comparison of turbulence and dispersion coefficients , 2011 .

[5]  O. E. Potter,et al.  Ozone decomposition in a 0.254 m diameter circulating fluidized bed reactor , 1993 .

[6]  D. Gunn.  Transfer of heat or mass to particles in fixed and fluidised beds , 1978 .

[7]  W. Ranz.  Evaporation from drops : Part II , 1952 .

[8]  Wei Ge,et al.  Simulation of Heterogeneous Structure in a Circulating Fluidized-Bed Riser by Combining the Two-Fluid Model with the EMMS Approach , 2004 .

[9]  Rahbar Rahimi,et al.  CFD simulation of gas-solid bubbling fluidized bed containing FCC particles , 2009 .

[10]  Pornpote Piumsomboon,et al.  Kinetic theory based computation of PSRI riser: Part I—Estimate of mass transfer coefficient , 2009 .

[11]  Todd Pugsley,et al.  Simulation and experimental validation of a freely bubbling bed of FCC catalyst , 2003 .

[12]  O. Bolland,et al.  DESCRIBING MASS TRANSFER IN CIRCULATING FLUIDIZED BEDS BY OZONE DECOMPOSITION , 2001 .

[13]  R. Jackson,et al.  Frictional–collisional constitutive relations for granular materials, with application to plane shearing , 1987, Journal of Fluid Mechanics.

[14]  S. Gu,et al.  The influence of multiple tubes on the tube-to-bed heat transfer in a fluidised bed , 2010 .

[15]  Sergei Stepanovich Zabrodskii.  Hydrodynamics and heat transfer in fluidized beds , 1966 .

[16]  Kai H. Luo,et al.  Two-dimensional and three-dimensional computational studies of hydrodynamics in the transition from bubbling to circulating fluidised bed , 2010 .

[17]  John R. Grace,et al.  Influence of particle size distribution on the performance of fluidized bed reactors , 1991 .

[18]  Ronald W. Breault,et al.  Computation of gas and solid dispersion coefficients in turbulent risers and bubbling beds , 2007 .

[19]  Kai H. Luo,et al.  Study of wall-to-bed heat transfer in a bubbling fluidised bed using the kinetic theory of granular flow , 2010 .

[20]  Pornpote Piumsomboon,et al.  Kinetic theory based computation of PSRI riser: Part II—Computation of mass transfer coefficient with chemical reaction , 2009 .

[21]  Pornpote Piumsomboon,et al.  A computational fluid dynamics design of a carbon dioxide sorption circulating fluidized bed , 2010 .

[22]  Ronald W. Breault,et al.  A review of gas–solid dispersion and mass transfer coefficient correlations in circulating fluidized beds , 2006 .

[23]  Owen E. Potter,et al.  Experimental investigation of models for fluidized bed catalytic reactors , 1976 .

[24]  Sai Gu,et al.  CFD modelling of the fast pyrolysis of biomass in fluidised bed reactors. Part B: Heat, momentum and mass transport in bubbling fluidised beds , 2009 .

[25]  Pornpote Piumsomboon,et al.  CFD modeling of tapered circulating fluidized bed reactor risers: Hydrodynamic descriptions and chemical reaction responses , 2010 .

[26]  M. Streat,et al.  Mass transfer in fixed and fluidized beds , 1985 .

[27]  A. Bridgwater,et al.  CFD modelling of the fast pyrolysis of biomass in fluidised bed reactors, Part A: Eulerian computation of momentum transport in bubbling fluidised beds , 2008 .

[28]  Sai Gu,et al.  Numerical Comparison of the Drag Models of Granular Flows Applied to the Fast Pyrolysis of Biomass , 2010 .

[29]  Simulation of Two-Phase Gas/Particle Flow and Ozone Decomposition in a 0.25m I.D. Riser , 1995 .

[30]  F. Taghipour,et al.  Experimental and computational study of gas¿solid fluidized bed hydrodynamics , 2005 .