New leak element using sintered stainless steel filter for in-situ calibration of ionization gauges and quadrupole mass spectrometers

[1]  H. Yoshida,et al.  Stability tests of quadrupole mass spectrometer by two-stage flow-dividing system , 2010 .

[2]  H. Yoshida,et al.  Stability tests of ionization gauges using two-stage flow-dividing system , 2009 .

[3]  K. Jousten,et al.  Comparison of the stability of hot and cold cathode ionization gauges , 2003 .

[4]  Y. Hirohata.  Quantitative Analysis of Hydrogen by Thermal Desorption Spectroscopy (TDS) , 1999 .

[5]  Patrick J. Abbott,et al.  Long‐term stability of Bayard–Alpert gauge performance: Results obtained from repeated calibrations against the National Institute of Standards and Technology primary vacuum standard , 1995 .

[6]  C. Tilford,et al.  Metrological characteristics of a group of quadrupole partial pressure analyzers , 1990 .

[7]  M. Bergoglio,et al.  Summary Abstract: Changes in time of the metrological characteristics of a quadrupole mass spectrometer , 1987 .

[8]  C. Tilford,et al.  Long‐term stability of two types of hot cathode ionization gauges , 1985 .

[9]  K. Poulter,et al.  Long term behaviour of ionization gauges , 1981 .

[10]  R. D. Present,et al.  Separation of a Gas Mixture Flowing through a Long Tube at Low Pressure , 1949 .

[11]  M. Hirata,et al.  Development of a Constant Pressure Type Flowmeter for the Vacuum Standard , 2010 .

[12]  H. Yoshida,et al.  Two-stage flow-dividing system for the calibration of vacuum gauges , 2008 .

[13]  J. Yuyama,et al.  Characteristics of the Axial-symmetric Transmission Gauge: Deviation and Long Term Stability of Sensitivity Factor , 2008 .

[14]  Charles D. Ehrlich,et al.  Recommended practices for the calibration and use of leaks , 1992 .