A new SMPS nonpunch thru IGBT replace MOSFET in SMPS high frequency applications

The continuous request from the market for higher power density and lower cost in commercial power supplies has forced semiconductor manufacturer to push device optimization to the limit or to develop new device solutions. Some of the new devices can surely improve performances, but in some cases the price to pay for increased complexity is too high. The IGBT device has a long history of success in motor drive and inverter applications, where switching frequencies are relatively low compared to SMPS. For this reason the development of new devices has always been driven by different requirements than SMPS ones. An NPT IGBT family has been developed and optimized targeting specifically SMPS applications. This paper shows the feature of this device in a critical comparison with equivalent products available on the marked today.

[1]  Steven T. Peake,et al.  Power semiconductor devices , 1995 .

[2]  Huibin Zhu,et al.  Switching characteristics of NPT- and PT-IGBTs under zero-voltage switching conditions , 1999, Conference Record of the 1999 IEEE Industry Applications Conference. Thirty-Forth IAS Annual Meeting (Cat. No.99CH36370).

[3]  T. Laska,et al.  Ultra thin-wafer technology for a new 600 V-NPT-IGBT , 1997, Proceedings of 9th International Symposium on Power Semiconductor Devices and IC's.

[4]  M. Cotorogea,et al.  Detailed analysis of different short-circuit conditions for nonpunch-through IGBTs , 2000, 7th IEEE International Power Electronics Congress. Technical Proceedings. CIEP 2000 (Cat. No.00TH8529).

[5]  J. Sack,et al.  A new concept for a non punch through IGBT with MOSFET like switching characteristics , 1989, 20th Annual IEEE Power Electronics Specialists Conference.