A Multilevel Class-D CMOS Power Amplifier for an Out-Phasing Transmitter With a Nonisolated Power Combiner

This brief presents a nonisolated multilevel linear amplifier with nonlinear component (LINC) power amplifier (PA) implemented in a standard 0.18-μm complementary metal-oxide- semiconductor process. Using a nonisolated power combiner, the overall power efficiency is increased by reducing the wasted power at the combined out-phased signal; however, the efficiency at low power still needs to be improved. To further improve the efficiency of the low-power (LP) mode, we propose a multiple-output power-level LINC PA, with load modulation implemented by switches. In addition, analysis of the proposed design on the system level as well as the circuit level was performed to optimize its performance. The measurement results demonstrate that the proposed technique maintains more than 45% power-added efficiency (PAE) for peak power at 21 dB for the high-power mode and 17 dBm for the LP mode at 600 MHz. The PAE for a 6-dB peak-to-average ratio orthogonal frequency-division multiplexing modulated signal is higher than 24% PAE in both power modes. To the authors' knowledge, the proposed output-phasing PA is the first implemented multilevel LINC PA that uses quarter-wave lines without multiple power supply sources.

[1]  L.E. Larson,et al.  CMOS Outphasing Class-D Amplifier With Chireix Combiner , 2007, IEEE Microwave and Wireless Components Letters.

[2]  H. Chireix.  High Power Outphasing Modulation , 1935, Proceedings of the Institute of Radio Engineers.

[3]  Atila Alvandpour,et al.  A +32 dBm 1.85 GHz class-D outphasing RF PA in 130nm CMOS for WCDMA/LTE , 2011, 2011 Proceedings of the ESSCIRC (ESSCIRC).

[4]  Joy Laskar,et al.  Highly efficient uneven multi-level linc transmitter , 2009 .

[5]  Hossein Hashemi,et al.  2.9 A 29dBm 18.5% peak PAE mm-Wave digital power amplifier with dynamic load modulation , 2015, 2015 IEEE International Solid-State Circuits Conference - (ISSCC) Digest of Technical Papers.

[6]  David R. Cox,et al.  Linear Amplification with Nonlinear Components , 1974, IEEE Trans. Commun..

[7]  Ockgoo Lee,et al.  An Amplitude and Phase Mismatches Calibration Technique for the LINC Transmitter With Unbalanced Phase Control , 2011, IEEE Transactions on Vehicular Technology.

[8]  An-Yeu Wu,et al.  Multilevel LINC System Designs for Power Efficiency Enhancement of Transmitters , 2009, IEEE Journal of Selected Topics in Signal Processing.

[9]  SungWon Chung,et al.  A 2.4-GHz, 27-dBm Asymmetric Multilevel Outphasing Power Amplifier in 65-nm CMOS , 2012, IEEE Journal of Solid-State Circuits.

[10]  B. Wooley,et al.  A CMOS RF power amplifier with parallel amplification for efficient power control , 2001, 2001 IEEE International Solid-State Circuits Conference. Digest of Technical Papers. ISSCC (Cat. No.01CH37177).

[11]  R. Kaunisto,et al.  A 2.14-GHz Chireix outphasing transmitter , 2005, IEEE Transactions on Microwave Theory and Techniques.

[12]  Yorgos Palaskas,et al.  A Transformer-Combined 31.5 dBm Outphasing Power Amplifier in 45 nm LP CMOS With Dynamic Power Control for Back-Off Power Efficiency Enhancement , 2012, IEEE Journal of Solid-State Circuits.

[13]  S. C. Cripps,et al.  RF Power Amplifiers for Wireless Communications , 1999 .

[14]  Ockgoo Lee,et al.  Multi-level LINC transmitter with non-isolated power combiner , 2013 .

[15]  Ockgoo Lee,et al.  A Multi-Level and Multi-Band Class-D CMOS Power Amplifier for the LINC System in the Cognitive Radio Application , 2010, IEEE Microwave and Wireless Components Letters.

[16]  William R. Eisenstadt,et al.  LINC power amplifier combiner method efficiency optimization , 2000, IEEE Trans. Veh. Technol..