A method to predict geomechanical properties and model well stability in horizontal boreholes

Abstract A methodology is proposed to quickly assess the stability risk for horizontal wells drilled in coal seams. The first task involves the estimation of strength and deformation parameters of the coal by indirect methods, such as the use of core description to assign a Geological Strength Index (GSI). The second task involves the use of a finite element analysis called FLAC to investigate factors such as the depth of fluid penetration while drilling the horizontal well and the stability of the wellbore during simulated production. These two factors are important because coal fines generated by the drill bit action are carried by the drilling fluid into the cleat system of the coal, thereby plugging the permeability pathways, and causing formation damage. On the other hand, a wellbore that may become unstable during pressure drawdown would require a perforated or slotted production liner. In this study, the conditions of drilling and production necessary for a stable horizontal well drilled into a Mannville coal seam at 750–800 m in the central Alberta Plains, were studied. Modeling showed that the depth of fluid penetration would be at least 2.2 m if there is no filter cake formation while drilling underbalanced. Drilling fluid penetration would be minimal if a filter cake is formed under overbalanced conditions. Furthermore, FLAC analysis showed that drilling a smaller diameter hole (5 cm) would be preferable because this size results in a stable wellbore during production compared to the standard 15-cm diameter hole.

[1]  R. Goodman.  Introduction to Rock Mechanics , 1980 .

[2]  E. T. Brown,et al.  EMPIRICAL STRENGTH CRITERION FOR ROCK MASSES , 1980 .

[3]  J. Bell.  In-situ stress and coal bed methane potential in Western Canada , 2006 .

[4]  P. K. Kaiser,et al.  Estimation of rock mass deformation modulus and strength of jointed hard rock masses using the GSI system , 2004 .

[5]  David D. Pollard,et al.  Fundamentals of Structural Geology , 2005 .

[6]  Nathan Deisman,et al.  Unconventional geomechanical testing on coal for coalbed reservoir well design: The Alberta Foothills and Plains , 2008 .

[7]  S. M. Willson,et al.  New Model for Predicting the Rate of Sand Production , 2002 .

[8]  Ian D. Palmer,et al.  Coal Failure and Consequences for Coalbed Methane Wells , 2005 .

[9]  T. Gentzis,et al.  Coalbed methane producibility from the Mannville coals in Alberta, Canada: A comparison of two areas , 2008 .

[10]  Terrence Paul Medhurst.  Estimation of the in situ strength and deformability of coal for engineering design , 1996 .

[11]  Evert Hoek,et al.  Variability of the engineering properties of rock masses quantified by the geological strength index: the case of ophiolites with special emphasis on tunnelling , 2006 .

[12]  Nathan Deisman,et al.  Geomechanical properties and permeability of coals from the Foothills and Mountain regions of western Canada , 2007 .

[13]  F. M. Dawson,et al.  An assessment of coalbed methane exploration projects in Canada , 2000 .

[14]  Thomas Gentzis,et al.  Stability analysis of a horizontal coalbed methane well in the Rocky Mountain Front Ranges of southeast British Columbia, Canada , 2009 .

[15]  C. J. Kenter,et al.  Horizontal wellbore stability and sand production in weakly consolidated sandstones , 2000 .

[16]  Evert Hoek,et al.  Practical estimates of rock mass strength , 1997 .