Analysis and Design of a Fully-Integrated High-Power Differential CMOS T/R Switch and Power Amplifier Using Multi-Section Impedance Transformation Technique

In this paper, a new topology for a high-power single-pole-double-throw (SPDT) antenna switch is presented, and its loss mechanisms are fully analyzed. The differential architecture is employed in the proposed switch implementation to prevent unwanted channel formations of OFF-state Rx switch transistors by relieving the voltage swing over the Rx switch devices. In addition to that, the load impedance seen by the Tx switch is stepped down to reduce the voltage swing even more, allowing the antenna switch to handle a high-power signal without distortions. To drop the switch operating impedance, two matching networks are required at the input and the output of the Tx switch, respectively, and they are carefully implemented considering the integration issue of the front-end circuitries. From the loss analysis of the whole signal path, an optimum switch operating impedance is decided in view of a trade-off between power handling capability and insertion loss of the antenna switch. The insertion loss of the proposed design is compared to the conventional design with electromagnetic (EM) simulated transformer and inductors. The proposed antenna switch is implemented in a standard 0.18 µm CMOS process, and all switch devices adopt the deep n-well structure. The measured performance of the proposed transmitter front-end chain shows a 1 dB compression point (P1dB) of 32.1 dBm with 38.3% power-added efficiency (PAE) at 1.9 GHz.

[1]  Haifeng Xu,et al.  A 31.3-dBm Bulk CMOS T/R Switch Using Stacked Transistors With Sub-Design-Rule Channel Length in Floated p-Wells , 2007, IEEE Journal of Solid-State Circuits.

[2]  A. van Bezooijen,et al.  Miniaturized Quad-Band Front-End Module for GSM using Si BiCMOS and passive integration technologies , 2006, 2006 Bipolar/BiCMOS Circuits and Technology Meeting.

[3]  S.S. Wong,et al.  Integrated CMOS transmit-receive switch using LC-tuned substrate bias for 2.4-GHz and 5.2-GHz applications , 2004, IEEE Journal of Solid-State Circuits.

[4]  A. Tombak,et al.  High-Resistivity SOI CMOS Cellular Antenna Switches , 2009, 2009 Annual IEEE Compound Semiconductor Integrated Circuit Symposium.

[5]  Jeongmin Jeon,et al.  A UHF CMOS Transceiver Front-end with a Resonant TR Switch , 2007, 2007 IEEE Radio and Wireless Symposium.

[6]  N. Suematsu,et al.  21.5-dBm power-handling 5-GHz transmit/receive CMOS switch realized by voltage division effect of stacked transistor configuration with depletion-layer-extended transistors (DETs) , 2004, IEEE Journal of Solid-State Circuits.

[7]  Joy Laskar,et al.  Analysis and Design of Fully Integrated High-Power Parallel-Circuit Class-E CMOS Power Amplifiers , 2010, IEEE Transactions on Circuits and Systems I: Regular Papers.

[8]  K. O. Kenneth,et al.  Single-pole double-throw CMOS switches for 900-MHz and 2.4-GHz applications on p-silicon substrates , 2004, IEEE J. Solid State Circuits.

[9]  Michiel Steyaert,et al.  A 2.45-GHz 0.13-$\mu{\hbox {m}}$ CMOS PA With Parallel Amplification , 2007, IEEE Journal of Solid-State Circuits.

[10]  J. Laskar,et al.  A 1.8-GHz 33-dBm $P$ 0.1-dB CMOS T/R Switch Using Stacked FETs With Feed-Forward Capacitors in a Floated Well Structure , 2009, IEEE Transactions on Microwave Theory and Techniques.

[11]  Chang-Tsung Fu,et al.  A Fully Integrated Ultra-Low Insertion Loss T/R Switch for 802.11b/g/n Application in 90 nm CMOS Process , 2009, IEEE Journal of Solid-State Circuits.

[12]  Y. Ohishi,et al.  A GaAs high-power RF single-pole double-throw switch IC for digital mobile communication system , 1994 .

[13]  Ali Hajimiri,et al.  Fully integrated CMOS power amplifier design using the distributed active-transformer architecture , 2002, IEEE J. Solid State Circuits.

[14]  Qiang Li,et al.  CMOS T/R Switch Design: Towards Ultra-Wideband and Higher Frequency , 2007, IEEE Journal of Solid-State Circuits.

[15]  Ockgoo Lee,et al.  A high power CMOS differential T/R switch using multi-section impedance transformation technique , 2010, 2010 IEEE Radio Frequency Integrated Circuits Symposium.

[16]  Ockgoo Lee,et al.  Design and Analysis of CMOS T/R Switches With the Impedance Transformation Technique , 2017, IEEE Microwave and Wireless Components Letters.

[17]  Zuo-Min Tsai,et al.  Design and analysis for a miniature CMOS SPDT switch using body-floating technique to improve power performance , 2006, IEEE Transactions on Microwave Theory and Techniques.

[18]  K. O. Kenneth,et al.  A 0.5-μm CMOS T/R switch for 900-MHz wireless applications , 2001, IEEE J. Solid State Circuits.

[19]  Ockgoo Lee,et al.  Power-Combining Transformer Techniques for Fully-Integrated CMOS Power Amplifiers , 2008, IEEE Journal of Solid-State Circuits.

[20]  D. Kerr,et al.  A Silicon RFCMOS SOI Technology for Integrated Cellular/WLAN RF TX Modules , 2007, 2007 IEEE/MTT-S International Microwave Symposium.

[21]  Ali Hajimiri,et al.  Distributed active transformer-a new power-combining and impedance-transformation technique , 2002 .

[22]  H.-C. Chung,et al.  A highly integrated quad-band GSM TX-front-end-module , 2003, 25th Annual Technical Digest 2003. IEEE Gallium Arsenide Integrated Circuit (GaAs IC) Symposium, 2003..

[23]  A.A. Abidi,et al.  RF CMOS comes of age , 2004, 2003 Symposium on VLSI Circuits. Digest of Technical Papers (IEEE Cat. No.03CH37408).