Full-Scale Wind Turbine Vibration Signature Analysis

A sample of healthy wind turbines from the same wind farm with identical sizes and designs was investigated to determine the average vibrational signatures of the drive train components during normal operation. The units were variable-speed machines with three blades. The rotor was supported by two bearings, and the drive train connected to an intermediate three-stage planetary/helical gearbox. The nominal 2 MW output power was regulated using blade pitch adjustment. Vibrations were measured in exactly the same positions using the same type of sensors over a six-month period covering the entire range of operating conditions. The data set was preliminary validated to remove outliers based on the theoretical power curves. The most relevant frequency peaks in the rotor, gearbox, and generator vibrations were detected and identified based on averaged power spectra. The amplitudes of the peaks induced by a common source of excitation were compared in different measurement positions. A wind speed dependency of broadband vibration amplitudes was also observed. Finally, a fault detection case is presented showing the change of vibration signature induced by a damage in the gearbox.

[1]  Andrew Kusiak,et al.  Analysis of wind turbine vibrations based on SCADA data , 2010 .

[2]  Wenyi Liu,et al.  Wind turbine fault diagnosis based on Morlet wavelet transformation and Wigner-Ville distribution , 2010 .

[3]  Erich Hau,et al.  Wind Turbines: Fundamentals, Technologies, Application, Economics , 1999 .

[4]  Mayorkinos Papaelias,et al.  Condition monitoring of wind turbines: Techniques and methods , 2012 .

[5]  David Infield,et al.  Online wind turbine fault detection through automated SCADA data analysis , 2009 .

[6]  Anindya Ghoshal,et al.  Structural health monitoring techniques for wind turbine blades , 2000 .

[7]  Peter Tavner,et al.  Condition monitoring and fault diagnosis of a wind turbine synchronous generator drive train , 2009 .

[8]  Andrew Kusiak,et al.  The prediction and diagnosis of wind turbine faults , 2011 .

[9]  Sung-Hoon Ahn,et al.  Condition monitoring and fault detection of wind turbines and related algorithms: A review , 2009 .

[10]  Matthew J. Watson,et al.  Integrating Oil Health and Vibration Diagnostics for Reliable Wind Turbine Health Predictions , 2011 .

[11]  Sung-Hoon Ahn,et al.  Practical aspects of a condition monitoring system for a wind turbine with emphasis on its design, system architecture, testing and installation , 2010 .

[12]  Xavier Escaler,et al.  Wind Speed Dependency of Low-Frequency Vibration Levels in Full-Scale Wind Turbines , 2015 .

[13]  Wenyi Liu,et al.  A new wind turbine fault diagnosis method based on the local mean decomposition , 2012 .

[14]  Alhussein Albarbar,et al.  Wind turbine blades condition assessment based on vibration measurements and the level of an empirically decomposed feature , 2012 .

[15]  Tongdan Jin,et al.  Condition based maintenance optimization for wind power generation systems under continuous monitoring , 2011 .

[16]  Simon J. Watson,et al.  Physics of Failure approach to wind turbine condition based maintenance , 2009 .

[17]  Yingning Qiu,et al.  Wind turbine condition monitoring: technical and commercial challenges , 2014 .