Experimental study of flame stabilization in low Reynolds and Dean number flows in curved mesoscale ducts

Abstract Flame stabilization during non-premixed combustion in curved ducts with a diameter of the order of magnitude of the premixed flame thickness of the reactants was investigated experimentally, since it has been established that this is a configuration with potential advantages in the context of “micro”-combustion. It was shown that, in such “mesoscale” tubes, a stable flame oscillation including extinction/re-ignition phenomena can be established for steady boundary conditions. These oscillations lead, under appropriate conditions, to sound emission in the 50–350 Hz range. This was a mode of stabilization in addition to the “classical” steady flamelet, stabilized through thermal losses to the duct walls at higher values of the Reynolds number. Curvature of the duct was shown to have minimal effect on reactant mixing, which was diffusion-controlled, but significantly affected flame thickness and stabilization. To probe the fuel-oxidizer mixing in the U-shaped, optically accessible tubes, laser induced fluorescence of acetone fuel dopant was used, and the flame structure was studied using OH PLIF. The various stabilization regimes are discussed in terms of the Reynolds and Dean numbers of the tube flow.

[1]  V. Kurdyumov,et al.  Lewis number effect on the propagation of premixed laminar flames in narrow open ducts , 2002 .

[2]  P. S. Wyckoff,et al.  On the Adequacy of Certain Experimental Observables as Measurements of Flame Burning Rate , 1998 .

[3]  H. G. Kim,et al.  Boundary-velocity gradient and premixed flame blowoff in U-bend tubes with secondary flow , 2003 .

[4]  J. Mantzaras,et al.  An experimental and numerical investigation of homogeneous ignition in catalytically stabilized combustion of hydrogen/air mixtures over platinum , 2002 .

[5]  W. R. Dean.  XVI. Note on the motion of fluid in a curved pipe , 1927 .

[6]  Gao Min,et al.  On thermoelectric power conversion from heat recirculating combustion systems , 2002 .

[7]  P. Ronney.  Analysis of non-adiabatic heat-recirculating combustors , 2003 .

[8]  J. Daou,et al.  Influence of conductive heat-losses on the propagation of premixed flames in channels , 2002 .

[9]  J. Ellzey,et al.  Effects of thermal boundary conditions on flame shape and quenching in ducts , 1998 .

[10]  S. Crow,et al.  Orderly structure in jet turbulence , 1971, Journal of Fluid Mechanics.

[11]  D. Kyritsis,et al.  Mesoscale power generation by a catalytic combustor using electrosprayed liquid hydrocarbons , 2002 .

[12]  F. Weinberg,et al.  Limits to energy release and utilisation from chemical fuels , 1975, Nature.

[13]  M. Matalon,et al.  Radiation losses as a driving mechanism for flame oscillations , 2002 .

[14]  F. Weinberg,et al.  A burner for mixtures of very low heat content , 1974, Nature.

[15]  Sébastien Candel,et al.  Combustion control and sensors: a review , 2002 .

[16]  Yiguang Ju,et al.  An analysis of sub-limit flame dynamics using opposite propagating flames in mesoscale channels , 2003 .

[17]  W. R. Dean.  LXXII. The stream-line motion of fluid in a curved pipe (Second paper) , 1928 .

[18]  A. Carlos Fernandez-Pello,et al.  Micropower generation using combustion: Issues and approaches , 2002 .