The Use of Functionally Graded Poly-SiGe Layers for MEMS Applications

It is difficult to meet all the different material and economical requirements posed to a MEMS structural layer that can be integrated with the electronics on the same substrate using a single layer process. Therefore a multilayer process, which uses a combination of a CVD crystallization layer and a high-growth rate PECVD bulk layer was developed. High-quality films with excellent electrical and mechanical properties can be obtained at low temperature (#450°C) and high deposition rates (~100 nm/min). Fine-tuning of the stress gradient is accomplished by the use of a top stress compensation layer, whose optimal thickness was estimated from an evaluation of the stress gradient profile over thickness. These layers have been used for processing a 10 µm thick poly-SiGe gyroscope on top of a standard 0.35 µm CMOS process.

[1]  H. Bender,et al.  Comparison between wet HF etching and vapor HF etching for sacrificial oxide removal , 2000 .

[2]  W. Chen,et al.  EFFECTS OF SIH4, GEH4, AND B2H6 ON THE NUCLEATION AND DEPOSITION OF POLYCRYSTALLINE SI1-XGEX FILMS , 1994 .

[3]  Wolfgang Kuehnel,et al.  A surface micromachined silicon accelerometer with on-chip detection circuitry , 1994 .

[4]  Sherif Sedky,et al.  IR bolometers made of polycrystalline silicon germanium , 1998 .

[5]  P. Houtte,et al.  Effect of in situ boron doping on properties of silicon germanium films deposited by chemical vapor deposition at 400 °C , 2001 .

[6]  Ann Witvrouw,et al.  New low-stress PECVD poly-SiGe Layers for MEMS , 2003 .

[7]  Sherif Sedky,et al.  Characterization and optimization of infrared poly SiGe bolometers , 1999 .

[8]  P. De Moor,et al.  Why CMOS-integrated transducers? A review , 2000 .

[9]  M. Madou.  Fundamentals of microfabrication , 1997 .

[10]  R. Howe,et al.  Polycrystalline silicon-germanium films for integrated microsystems , 2003 .

[11]  G. Cody,et al.  Thermal Conductivity of Ge-Si Alloys at High Temperatures , 1962 .

[12]  Robert Mertens,et al.  Thin-film boron-doped polycrystalline silicon70%-germanium30% for thermopiles , 1996 .

[13]  Tong-Yi Zhang,et al.  Rapid thermal annealing of polysilicon thin films , 1998 .

[14]  John L. Crassidis,et al.  Sensors and actuators , 2005, Conference on Electron Devices, 2005 Spanish.

[15]  Larry J. Hornbeck,et al.  Digital Light Processing for high-brightness high-resolution applications , 1997, Electronic Imaging.

[16]  H. Bender,et al.  Experimental determination of the maximum post-process annealing temperature for standard CMOS wafers , 2001 .

[17]  H. Kahn,et al.  A new technique for producing large-area as-deposited zero-stress LPCVD polysilicon films: the MultiPoly process , 2000, Journal of Microelectromechanical Systems.

[18]  A. Chand,et al.  Strain studies in LPCVD polysilicon for surface micromachined devices , 1999 .

[19]  Ann Witvrouw,et al.  Poly SiGe, a promising material for MEMS monolithic integration with the driving electronics , 2002 .