Open circuit voltage and methanol crossover in DMFCs

It is difficult to definitely measure the open circuit voltage (OCV) of a direct methanol fuel cell (DMFC). For example, after a cell is changed from a loaded state to a no load, open circuit state, the voltage increases quickly and reaches a peak value in seconds. Some might use this peak voltage as the OCV. However, the voltage starts to decline quite rapidly following the peak, and it takes several minutes to become stabilized at a lower value. This stabilized, lower voltage should be used as the OCV. Another unique and interesting phenomenon is the rapid cell voltage increase following an initial instant decline when a load is applied to a DMFC. This increase is believed to be due to diminishing of excess methanol that accumulates at the cathode side during the open circuit period. The effects of air flow rate, methanol concentration and cell temperature on the OCV, methanol crossover and cell performance were also studied.

[1]  Shimshon Gottesfeld,et al.  Water and Methanol Uptakes in Nafion Membranes and Membrane Effects on Direct Methanol Cell Performance , 2000 .

[2]  W. Vielstich,et al.  Investigation of methanol crossover and single electrode performance during PEMDMFC operation: A study using a solid polymer electrolyte membrane fuel cell system , 1998 .

[3]  D. Jung,et al.  Performance of a direct methanol polymer electrolyte fuel cell , 1998 .

[4]  M. Bartolozzi,et al.  A Comparative Investigation of Proton and Methanol Transport in Fluorinated Ionomeric Membranes , 2000 .

[5]  V. Hacker,et al.  Direct methanol–air fuel cells with membranes plus circulating electrolyte , 2001 .

[6]  David A. J. Rand,et al.  Direct methanol–air fuel cells for road transportation , 1999 .

[7]  K. Potje-Kamloth,et al.  Comparative study of methanol crossover across electropolymerized and commercial proton exchange membrane electrolytes for the acid direct methanol fuel cell , 1998 .

[8]  Keith Scott,et al.  The degree and effect of methanol crossover in the direct methanol fuel cell , 1998 .

[9]  James Larminie,et al.  Fuel Cell Systems Explained , 2000 .

[10]  Angelika Heinzel,et al.  A review of the state-of-the-art of the methanol crossover in direct methanol fuel cells , 1999 .

[11]  Robert F. Savinell,et al.  Real‐Time Mass Spectrometric Study of the Methanol Crossover in a Direct Methanol Fuel Cell , 1996 .

[12]  W. Preidel,et al.  Status of the development of a direct methanol fuel cell , 1999 .

[13]  S. Wasmus,et al.  Methanol oxidation and direct methanol fuel cells: a selective review 1 In honour of Professor W. Vi , 1999 .

[14]  Keith Scott,et al.  Engineering aspects of the direct methanol fuel cell system , 1999 .

[15]  Shuzi Hayase,et al.  Modified Nafion 117 as an Improved Polymer Electrolyte Membrane for Direct Methanol Fuel Cells , 2001 .

[16]  W. M. Taama,et al.  The impact of mass transport and methanol crossover on the direct methanol fuel cell , 1999 .