Experimental characterization of the punch through shear strength of an ultra-high performance concrete

Abstract The paper describes the quasi-static and dynamic experimental methods used to examine the confined shear strength of an Ultra-High Performance Concrete, with and without the presence of steel fibers in the concrete composition. The experimental setup that employs a hydraulic press allows investigating the concrete shear strength under quasi-static loading regime while dynamic shear strength is characterized by subjecting concrete samples to dynamic loading through a modified Split Hopkinson Pressure Bar set-up. Both methods are based on a so called Punch Through Shear (PTS) test with a well-instrumented aluminum-alloy passive confinement ring that allows measuring the change of radial stress in the shear ligament throughout the test. First, four equally distributed radial notches have been performed on the concrete samples in order to deduce the radial stress in the shear ligament by suppressing self-confinement of the sample peripheral part. However, by analyzing the strain gauge data obtained from the confinement ring, it has been noticed that these were insufficient, especially for fiber-reinforced samples, resulting in subsequently practicing eight radial notches through the peripheral part of the samples. The results obtained from both procedures in addition to post-mortem observations are reported and discussed. It is concluded that the apparent increase of shear strength under dynamic loading compared to the quasi-static response is the consequence of higher radial confinement stresses at high strain-rates that results from an alteration of fracturing in mode I prior to mode II cracking in the ligament.

[1]  Serdar Aydın,et al.  The effect of fiber properties on high performance alkali-activated slag/silica fume mortars , 2013 .

[2]  Weinong W Chen,et al.  Pulse shaping techniques for testing brittle materials with a split hopkinson pressure bar , 2002 .

[3]  P. Richard,et al.  Composition of reactive powder concretes , 1995 .

[4]  Oana Cazacu,et al.  Behavior of cementitious materials for high-strain rate conditions , 2006 .

[5]  François Hild,et al.  Dynamic Fragmentation of an Ultrahigh-Strength Concrete during Edge-On Impact Tests , 2008 .

[6]  G. Gary,et al.  A testing technique for concrete under confinement at high rates of strain , 2008 .

[7]  A. Arias,et al.  Role of porosity in controlling the mechanical and impact behaviours of cement-based materials , 2008 .

[8]  Erik Rybacki,et al.  Rock fracture toughness testing in Mode II—punch-through shear test , 2002 .

[9]  X. Nie,et al.  Annular Pulse Shaping Technique for Large-Diameter Kolsky Bar Experiments on Concrete , 2014 .

[10]  P. Forquin.  Influence of strain-rate and confining pressure on the shear strength of concrete , 2011 .

[11]  O. Bayard.  Approche multi-échelles du comportement mécanique des bétons à ultra hautes performances renforcés par des fibres courtes , 2003 .

[12]  P. Forquin,et al.  Experiments and mesoscopic modelling of dynamic testing of concrete , 2011 .

[13]  A. Arias,et al.  An experimental method of measuring the confined compression strength of geomaterials , 2007 .

[14]  K. Thoma,et al.  Spall experiments for the measurement of the tensile strength and fracture energy of concrete at high strain rates , 2006 .

[15]  T. Backers.  Fracture Toughness Determination and Micromechanics of Rock under Mode I and Mode II Loading , 2005 .

[16]  S. Millard,et al.  Dynamic enhancement of blast-resistant ultra high performance fibre-reinforced concrete under flexural and shear loading , 2010 .

[17]  I. Carol,et al.  Characterization of Concrete in Mixed Mode Fracture Under Confined Conditions , 2007 .

[18]  Pascal Forquin,et al.  An Experimental Method to Determine the Tensile Strength of Concrete at High Rates of Strain , 2010 .

[19]  Qingming Li,et al.  About the dynamic strength enhancement of concrete-like materials in a split Hopkinson pressure bar test , 2003 .

[20]  P. Forquin.  Influence of Free Water and Strain-Rate on the Shear Behaviour of Concrete , 2011 .

[21]  Su-Tae Kang,et al.  Investigation on the flexural behavior of UHPCC considering the effect of fiber orientation distribution , 2012 .

[22]  J. Watkins,et al.  Fracture toughness test for soll-cement samples in mode II , 1983 .

[23]  Young Soo Yoon,et al.  Material and bond properties of ultra high performance fiber reinforced concrete with micro steel fibers , 2014 .

[24]  P. Forquin,et al.  A Testing Technique to Characterise the Shear Behaviour of Concrete at High Strain-Rates , 2013 .