On the railway track dynamics with rail vibration absorber for noise reduction

A promising means to increase the decay rate of vibration along the rail is using a rail absorber for noise reduction. Compound track models with the tuned rail absorber are developed for investigation of the performance of the absorber on vibration reduction. Through analysis of the track dynamics with the rail absorber some guidelines are given on selection of the types and parameters for the rail absorber. It is found that a large active mass used in the absorber is beneficial to increase the decay rate of rail vibration. The effectiveness of the piecewise continuous absorber is moderate compared with the discrete absorber installed in the middle of sleeper span or at a sleeper. The most effective installation position for the discrete absorber is in the middle of sleeper span. Over high or over low loss factor of the damping material used in the absorber may degrade the performance on vibration reduction.

[1]  Paul J. Remington,et al.  Wheel/rail rolling noise, I: Theoretical analysis , 1987 .

[2]  David Thompson,et al.  Experimental validation of the twins prediction program for rolling noise. Pt.2: results , 1996 .

[3]  D. J. Mead.  A new method of analyzing wave propagation in periodic structures; Applications to periodic timoshenko beams and stiffened plates , 1986 .

[4]  David Thompson,et al.  Review of research into wheel/rail rolling noise reduction , 2006 .

[5]  Chris Jones,et al.  A tuned damping device for reducing noise from railway track , 2007 .

[6]  David Thompson,et al.  Theoretical optimization of track components to reduce rolling noise , 1996 .

[7]  T. X. Wu,et al.  The influence of the non-linear stiffness behaviour of rail pads on the track component of rolling noise , 1999 .

[8]  D. Thompson.  Wheel-rail Noise Generation, Part I: Introduction And Interaction Model , 1993 .

[9]  T. X. Wu,et al.  VIBRATION ANALYSIS OF RAILWAY TRACK WITH MULTIPLE WHEELS ON THE RAIL , 2001 .

[10]  Hugo Sol,et al.  A double tuned rail damper—increased damping at the two first pinned–pinned frequencies , 2003 .

[11]  Chris Jones,et al.  The use of decay rates to analyse the performance of railway track in rolling noise generation , 2006 .

[12]  Paul J. Remington,et al.  Wheel/rail rolling noise, II: Validation of the theory , 1987 .

[13]  David Thompson,et al.  EXPERIMENTAL VALIDATION OF THE TWINS PREDICTION PROGRAM FOR ROLLING NOISE, PART 1: DESCRIPTION OF THE MODEL AND METHOD , 1996 .