Static and Dynamic Stability Estimation of Diecutter

In this study, static and dynamic stability estimations on the diecutter with finite element modelling were carried out to be creased and cut away printed sheet exactly. To cut away the sheet exactly, the large force should be pressured on diecutter. And which affects not only the quality of produced sheets but also the stability of diecutter. The analyses with and without the tare of diecutter were carried out with NASTRAN software on applying 400 ton force to its top and moving table respectively. It was known that maximum von-Mises stress of 221 Mpa in diecutter was occurred at the toggle, and it was smaller than the yield stress of 280 Mpa. And maximum deformation of 0.75 mm was occurred at the top table. The natural frequencies of 41, 102, 108, 115, and 134 Hz for the 1st, 2nd, 3rd, 4th and 5th mode, which had been determined by numerical simulation, were not coincided with the max. speeds of motor and moving table of 29 and 2 Hz. And which was verified by vibration test. Therefore it may be estimated that the structure of the diecutter is statically and dynamically stable.