Radio-frequency coils for ultra-high field magnetic resonance.

Radiofrequency (RF) coils are key components of magnetic resonance imaging (MRI) systems. The primary purpose of this review is to provide a basic theory of RF coil designs and their characterization by bench measurements, electromagnetic field simulations and MR measurements. With the continuing increase of magnetic field strength in MRI instruments, the RF wavelength in the subject under study becomes comparable to or smaller in size than the anatomical dimensions of the tissue under study, which amplifies the signal inhomogeneity. Also, RF energy increases quadratically with the Larmor frequency, which leads to increased heat deposition in the subject, especially at ultra-high field. Elegant RF coil designs are explored here to address these challenges.

[1]  P A Bottomley,et al.  Power deposition in whole-body NMR imaging. , 1981, Medical physics.

[2]  Michael Lustig,et al.  Screen-printed flexible MRI receive coils , 2016, Nature Communications.

[3]  K. Yee.  Numerical solution of initial boundary value problems involving maxwell's equations in isotropic media , 1966 .

[4]  P. Tofts,et al.  Fast, accurate, and precise mapping of the RF field in vivo using the 180° signal null , 2007, Magnetic resonance in medicine.

[5]  K. Uğurbil,et al.  Resolution improvements in in vivo 1H NMR spectra with increased magnetic field strength. , 1998, Journal of magnetic resonance.

[6]  C A T van den Berg,et al.  Characterization of transceive surface element designs for 7 tesla magnetic resonance imaging of the prostate: radiative antenna and microstrip , 2012, Physics in medicine and biology.

[7]  Michael B. Smith,et al.  Combination of optimized transmit arrays and some receive array reconstruction methods can yield homogeneous images at very high frequencies , 2005, Magnetic resonance in medicine.

[8]  Michael B. Smith,et al.  Central brightening due to constructive interference with, without, and despite dielectric resonance , 2005, Journal of magnetic resonance imaging : JMRI.

[9]  Peter Börnert,et al.  DREAM—a novel approach for robust, ultrafast, multislice B1 mapping , 2012, Magnetic resonance in medicine.

[10]  K. Uğurbil,et al.  Temperature and SAR calculations for a human head within volume and surface coils at 64 and 300 MHz , 2004, Journal of magnetic resonance imaging : JMRI.

[11]  Vasily L Yarnykh,et al.  Actual flip‐angle imaging in the pulsed steady state: A method for rapid three‐dimensional mapping of the transmitted radiofrequency field , 2007, Magnetic resonance in medicine.

[12]  Stuart Crozier,et al.  Improving SAR estimations in MRI using subject-specific models , 2012, Physics in medicine and biology.

[13]  Niels Kuster,et al.  The Virtual Family—development of surface-based anatomical models of two adults and two children for dosimetric simulations , 2010, Physics in medicine and biology.

[14]  Daniel K Sodickson,et al.  Characterization of a dielectric phantom for high-field magnetic resonance imaging applications. , 2014, Medical physics.

[15]  C N Chen,et al.  The field dependence of NMR imaging. II. Arguments concerning an optimal field strength , 1986, Magnetic resonance in medicine.

[16]  Theodoros Samaras,et al.  CEM43°C thermal dose thresholds: a potential guide for magnetic resonance radiofrequency exposure levels? , 2013, European Radiology.

[17]  Herbert Rinneberg,et al.  Patient safety concept for multichannel transmit coils , 2007, Journal of magnetic resonance imaging : JMRI.

[18]  P. Roemer,et al.  The NMR phased array , 1990, Magnetic resonance in medicine.

[19]  J. Griffiths,et al.  RF Coils for MRI , 2012 .

[20]  F. Wiesinger,et al.  B1 mapping by Bloch‐Siegert shift , 2010, Magnetic resonance in medicine.

[21]  Allen Taflove,et al.  Computational Electrodynamics the Finite-Difference Time-Domain Method , 1995 .

[22]  Andreas Peter,et al.  An MRI Receiver Coil Produced by Inkjet Printing Directly on to a Flexible Substrate , 2010, IEEE Transactions on Medical Imaging.

[23]  T. Ibrahim,et al.  Application of finite difference time domain method for the design of birdcage RF head coils using multi-port excitations. , 2000, Magnetic resonance imaging.

[24]  Thomas Neuberger,et al.  Experimental and numerical assessment of MRI‐induced temperature change and SAR distributions in phantoms and in vivo , 2010, Magnetic resonance in medicine.

[25]  Robert Turner,et al.  Fast MRI coil analysis based on 3-D electromagnetic and RF circuit co-simulation. , 2009, Journal of magnetic resonance.

[26]  S R Arridge,et al.  A simple method for investigating the effects of non-uniformity of radiofrequency transmission and radiofrequency reception in MRI. , 1998, The British journal of radiology.

[27]  Tobias Kober,et al.  SA2RAGE: A new sequence for fast B1+‐mapping , 2012, Magnetic resonance in medicine.

[28]  Aviad Hai,et al.  Molecular-Level Functional Magnetic Resonance Imaging of Dopaminergic Signaling , 2014, Science.

[29]  G. Metzger,et al.  Local B1+ shimming for prostate imaging with transceiver arrays at 7T based on subject‐dependent transmit phase measurements , 2008, Magnetic resonance in medicine.

[30]  C. Collins,et al.  Calculation of radiofrequency electromagnetic fields and their effects in MRI of human subjects , 2011, Magnetic resonance in medicine.

[31]  Mark E Ladd,et al.  RF excitation using time interleaved acquisition of modes (TIAMO) to address B1 inhomogeneity in high‐field MRI , 2010, Magnetic resonance in medicine.

[32]  O. Dössel,et al.  Toward individualized SAR models and in vivo validation , 2011, Magnetic resonance in medicine.

[33]  D. Hoult,et al.  The field dependence of NMR imaging. I. Laboratory assessment of signal‐to‐noise ratio and power deposition , 1986, Magnetic resonance in medicine.

[34]  Cornelis A T van den Berg,et al.  Specific absorption rate intersubject variability in 7T parallel transmit MRI of the head , 2013, Magnetic resonance in medicine.

[35]  R. Goebel,et al.  7T vs. 4T: RF power, homogeneity, and signal‐to‐noise comparison in head images , 2001, Magnetic resonance in medicine.

[36]  Lawrence J. Berliner,et al.  Ultra High Field Magnetic Resonance Imaging , 2006 .

[37]  D I Hoult,et al.  The signal-to-noise ratio of the nuclear magnetic resonance experiment. 1976. , 1976, Journal of magnetic resonance.

[38]  A. Shmuel,et al.  Imaging brain function in humans at 7 Tesla , 2001, Magnetic resonance in medicine.

[39]  Özlem Ipek,et al.  Intersubject local SAR variation for 7T prostate MR imaging with an eight‐channel single‐side adapted dipole antenna array , 2014, Magnetic resonance in medicine.

[40]  Gabriele Eichfelder,et al.  Local specific absorption rate control for parallel transmission by virtual observation points , 2011, Magnetic resonance in medicine.

[41]  H. S. Osborne,et al.  The international electrotechnical commission , 1953, Electrical Engineering.

[42]  K. Uğurbil,et al.  Experimental determination of the BOLD field strength dependence in vessels and tissue , 1997, Magnetic resonance in medicine.

[43]  Peter Andersen,et al.  Whole‐body imaging at 7T: Preliminary results , 2009, Magnetic resonance in medicine.

[44]  J. Pauly,et al.  Saturated double‐angle method for rapid B1+ mapping , 2006, Magnetic resonance in medicine.

[45]  James C. Lin,et al.  SAR and temperature: Simulations and comparison to regulatory limits for MRI , 2007, Journal of magnetic resonance imaging : JMRI.