Abstract Recent developments in pressure measurement technology, and unprecedented “big data” capabilities, have enabled the development of Database-Assisted Design (DAD), a powerful innovative approach to the design of tall buildings for wind. DAD eliminates unwieldy back-and-forth interactions between the wind and the structural engineer, needed in traditional practices if iterative designs are performed. Some structural engineers have shown interest in an alternative approach that uses equivalent static wind loads (ESWLs) in lieu of DAD. Such an approach is warranted if ESWLs induce in structural members demand-to-capacity indexes (DCIs) approximately equal to their peak counterparts obtained by DAD. This paper presents and assesses a simple procedure for calculating such ESWLs. The procedure uses an effective multiple points-in-time (MPIT) method for estimating combined peak wind effects, and accounts for wind directionality. A case study is presented that uses both the ESWL and DAD procedures, with the latter providing the requisite benchmark results. DCIs obtained from ESWLs based on the use of ten points-in-time (corresponding to 60 wind loading cases) were significantly closer to the benchmark DAD values than their counterparts based on the use of, e.g., four points-in-time (corresponding to 24 wind loading cases). For the building considered in this case study, ESWL-based design DCIs approximated to within approximately 3% the DCIs yielded by DAD. The approximation was found to be poorer for cases in which a single unfavorable wind direction is strongly dominant. The ESWL procedure is not applicable in its present form to structures with complex shapes. In all cases, the DAD procedure is the safest and most risk-consistent design option.
[1]
Andres Lepage,et al.
Wind Tunnel Methods
,
2006
.
[2]
Emil Simiu,et al.
Wind Effects on Structures
,
2019
.
[3]
Emil Simiu,et al.
Advances in the design of high-rise structures by the wind tunnel procedure: Conceptual framework
,
2015
.
[4]
Donghun Yeo,et al.
Second-Order Effects on Wind-Induced Structural Behavior of High-Rise Steel Buildings
,
2018
.
[5]
T. C. Eric Ho,et al.
Components of wind -tunnel analysis using force balance test data
,
2014
.
[6]
Donghun Yeo,et al.
Introductory tutorial for DAD: design examples of high-rise building for wind
,
2018
.
[7]
DongHun Yeo,et al.
Multiple Points-In-Time Estimation of Peak Wind Effects on Structures
,
2013
.
[8]
E. Simiu,et al.
Wind Load Factors for Use in the Wind Tunnel Procedure.
,
2017,
ASCE-ASME journal of risk and uncertainty in engineering systems. Part A, Civil Engineering.
[9]
Emil Simiu,et al.
High-Rise Reinforced Concrete Structures: Database-Assisted Design for Wind
,
2011
.
[10]
Xinzhong Chen,et al.
Wind load effects and equivalent static wind loads of tall buildings based on synchronous pressure measurements
,
2007
.
[11]
Yukio Tamura,et al.
Experimental evaluation of aerodynamic damping of tall buildings
,
1996
.