The scaling potential of barium sulphate in reverse osmosis systems

Abstract Barium sulphate scaling in reverse osmosis (RO) causes flux decline and potentially severe membrane damage. Existing methods, e.g. Du Pont, predict barite scaling when the concentrate is saturated. However, precipitation in supersaturated concentrate may be limited by slow nucleation kinetics, measured as long induction times. Induction time decreases, hence precipitation is more likely, with supersaturation and temperature. Therefore, induction time may be used to express the scaling potential of RO concentrate. This research aims to develop a more realistic method to predict barite scaling based on the assumption that an induction time (unsafe) can be defined, operating below which scaling will most likely occur in an RO system. While operating above a certain induction time (safe) should prevent scaling. Induction times were calculated for various supersaturation (employing Pitzer coefficients) and temperature conditions at an RO pilot plant using a previously derived relationship of measured induction time versus supersaturation at 25 °C. Safe (≥10 h) and unsafe (≤5 h) induction time limits, were derived from periods when scaling did and did not occur in the RO system and translated into safe and unsafe supersaturation limits for 5–25 °C. Use of these supersaturation limits allows more flexible operation in optimising RO recovery while avoiding scaling. The general validity of these limits needs to be verified in further pilot studies with feedwater of different quality and using different RO elements.

[1]  M. Tomson,et al.  The nucleation kinetics of strontium sulfate in NaCl solutions up to 6 m and 90°C with or without inhibitors , 1995 .

[2]  A. Myerson.  Handbook of Industrial Crystallization , 2002 .

[3]  O. Söhnel,et al.  Precipitation: Basic Principles and Industrial Applications , 1992 .

[4]  G. H. Nancollas,et al.  CHAPTER 9. MECHANISMS OF GROWTH AND DISSOLUTION OF SPARINGLY SOLUBLE SALTS , 1990 .

[5]  J. Hoek,et al.  BaSO4 solubility prediction in reverse osmosis membrane systems , 1999 .

[6]  J. Hoek,et al.  Stable barium sulphate supersaturation in reverse osmosis , 2000 .

[7]  J. E. Oddo,et al.  The Inhibition of gypsum and barite nucleation in NaCl brines at temperatures from 25 to 90°C , 1994 .

[8]  G. H. Nancollas,et al.  The crystal growth and dissolution of barium sulfate in the presence of additives , 1975 .

[9]  G. V. Rosmalen,et al.  Aspects of additives in precipitation processes: Performance of polycarboxylates in gypsum growth prevention , 1987 .

[10]  M. Tomson,et al.  The Nucleation Kinetics of Barium Sulfate in NaCl Solutions up to 6 m and 90°C , 1995 .

[11]  J. Mullin,et al.  Interpretation of crystallization induction periods , 1988 .

[12]  Margot Weijnen,et al.  The influence of various polyelectrolytes on the precipitation of gypsum , 1985 .

[13]  N. Eidelman,et al.  Reversal of trends in impurity effects on crystallization parameters , 1986 .

[14]  J. Kruithof,et al.  Integrated multi-objective membrane systems for surface water treatment: pre-treatment of nanofiltration by riverbank filtration and conventional ground water treatment☆ , 1998 .

[15]  A. Pervov.  Scale formation prognosis and cleaning procedure schedules in reverse osmosis systems operation , 1991 .

[16]  Dimo Kashchiev,et al.  Nucleation : basic theory with applications , 2000 .

[17]  P.A.C. Bonné,et al.  RO treatment: selection of a pretreatment scheme based on fouling characteristics and operating conditions based on environmental impact , 2000 .

[18]  G. H. Nancollas,et al.  A kinetic and morphological study of the seeded growth of calcium sulfate dihydrate in the presence of additives , 1975 .

[19]  A. E. Nielsen.  Kinetics of precipitation , 1964 .

[20]  G. M. van Rosmalen,et al.  Precipitation of barium sulfate: Induction time and the effect of an additive on nucleation and growth , 1992 .

[21]  D. Gunn,et al.  Kinetics and mechanisms of precipitations , 1972 .

[22]  C. Templeton.  Solubility of Barium Sulfate in Sodium Chloride Solutions from 25° to 95° C. , 1960 .