Numerical investigations of crack initiation in impulse steam turbine rotors subject to thermo-mechanical fatigue

Abstract The study presents the analysis of non-stationary stresses and fatigue cracking in impulse steam turbine rotors. Field experience with cracking of rotors is reviewed, and the most frequent crack locations are identified based on the same. Mathematical models of heat transfer and material constitutive behaviour used in numerical calculations of an intermediate pressure rotor are discussed. Calculations were performed with the help of finite element method for typical transient events including cold, warm, and hot start-ups and a shutdown. The highest stress and strain amplitudes were obtained in the heat grooves of a balance piston in which cracks were often observed during non-destructive testing. The number of cycles to crack initiation calculated based on the strain amplitudes correspond well with the operating experience of this type of rotors.

[1]  Tomasz Ochrymiuk.  Numerical investigations of the 3D transonic field and heat transfer at the over-tip casing in a HP-turbine stage , 2016 .

[2]  M. Banaszkiewicz.  Analysis of Rotating Components Based on a Characteristic Strain Model of Creep , 2016 .

[3]  Jayanta Das,et al.  Multiaxial fatigue life prediction of a high temperature steam turbine rotor using a critical plane approach , 2000 .

[4]  J. Badur,et al.  An advanced Thermal-FSI approach to flow heating/cooling , 2014 .

[5]  Z. Mazur,et al.  Steam turbine rotor discs failure evaluation and repair process implementation , 2015 .

[6]  T. Seeger,et al.  A Generalized Method for Estimating Multiaxial Elastic-Plastic Notch Stresses and Strains, Part 1: Theory , 1985 .

[7]  E. Poursaeidi,et al.  Effects of emergency and fired shut down on transient thermal fatigue life of a gas turbine casing , 2016 .

[8]  G. Glinka,et al.  Calculation of elasto-plastic strains and stresses in notches under multiaxial loading , 1994 .

[9]  O. Basquin.  The exponential law of endurance tests , 1910 .

[10]  Marco Boniardi,et al.  Failure analysis of a steam turbine rotor , 2011 .

[11]  Jun Li,et al.  Numerical investigation on the flow and heat transfer in a rotor-stator disc cavity , 2015 .

[12]  Mariusz Banaszkiewicz,et al.  Stress corrosion cracking of a 60MW steam turbine rotor , 2015 .

[13]  Hyojin Kim,et al.  Crack evaluation of the fourth stage blade in a low-pressure steam turbine , 2011 .

[14]  Mariusz Banaszkiewicz,et al.  Multilevel approach to lifetime assessment of steam turbines , 2015 .

[15]  Hans-Werner Ziegler.  A Modification of Prager's Hardening Rule , 1959 .

[16]  H. Neuber.  Theory of Stress Concentration for Shear-Strained Prismatical Bodies With Arbitrary Nonlinear Stress-Strain Law , 1961 .

[17]  M. Banaszkiewicz.  Online determination of transient thermal stresses in critical steam turbine components using a two-step algorithm , 2017 .

[18]  Mariusz Banaszkiewicz,et al.  On-line monitoring and control of thermal stresses in steam turbine rotors , 2016 .

[19]  J. C. García,et al.  Failure analysis of the 350 MW steam turbine blade root , 2009 .

[20]  M. Nurbanasari,et al.  Crack of a first stage blade in a steam turbine , 2014 .

[21]  A. Picasso,et al.  Investigation of turbine blade failure in a thermal power plant , 2013 .

[22]  Hyojin Kim,et al.  Crack evaluation and subsequent solution of the last stage blade in a low-pressure steam turbine , 2010 .

[23]  E. Poursaeidi,et al.  Non-uniform temperature distribution of turbine casing and its effect on turbine casing distortion , 2014 .

[24]  Maciej Roskosz,et al.  Thermal elongations in steam turbines with welded rotors made of advanced materials at supercritical steam parameters , 2009 .

[25]  Pei Liu,et al.  A finite element method approach to the temperature distribution in the inner casing of a steam turbine in a combined cycle power plant , 2016 .

[26]  V. Rastogi,et al.  Fractographic investigations of the failure of L-1 low pressure steam turbine blade , 2013 .

[27]  L. Coffin,et al.  A Study of the Effects of Cyclic Thermal Stresses on a Ductile Metal , 1954, Journal of Fluids Engineering.