Application of field synergy principle for optimization fluid flow and convective heat transfer in a tube bundle of a pre-heater

The big problems facing solar-assisted MED (multiple-effect distillation) desalination unit are the low efficiency and bulky heat exchangers, which worsen its systematic economic feasibility. In an attempt to develop heat transfer technologies with high energy efficiency, a mathematical study is established, and optimization analysis using FSP (field synergy principle) is proposed to support meaning of heat transfer enhancement of a pre-heater in a solar-assisted MED desalination unit. Numerical simulations are performed on fluid flow and heat transfer characteristics in a circular and elliptical tube bundle. The numerical results are analyzed using the concept of synergy angle and synergy number as an indication of synergy between velocity vector and temperature gradient fields. Heat transfer in elliptical tube bundle is enhanced significantly with increasing initial velocity of the feed seawater and field synergy number and decreasing of synergy angle. Under the same operating conditions of the two designs, the total average synergy angle is 78.97° and 66.31° in circular and elliptical tube bundle, respectively. Optimization of the pre-heater by FSP shows that in case of elliptical tube bundle design, the average synergy number and heat transfer rate are increased by 22.68% and 35.98% respectively.

[1]  Yang Yang,et al.  Effects of the Fouling on the Convective Heat Transfer Field Synergy in Round Tube , 2012 .

[2]  Adrian Bejan,et al.  Optimally staggered finned circular and elliptic tubes in forced convection , 2004 .

[3]  Hisham Ettouney,et al.  Performance of parallel feed multiple effect evaporation system for seawater desalination , 2000 .

[4]  Gábor Janiga,et al.  Systematic analysis of the heat exchanger arrangement problem using multi-objective genetic optimization , 2014 .

[5]  Noam Lior,et al.  Thermoeconomic analysis of a low-temperature multi-effect thermal desalination system coupled with a , 2011 .

[6]  Ming-Tsun Ke,et al.  The log mean heat transfer rate method of heat exchanger considering the influence of heat radiation , 2009 .

[7]  Lawrence L. Kazmerski,et al.  Energy Consumption and Water Production Cost of Conventional and Renewable-Energy-Powered Desalination Processes , 2013 .

[8]  A. S. Nafey,et al.  Thermo-economic analysis of solar thermal power cycles assisted MED-VC (multi effect distillation-vapor compression) desalination processes , 2011 .

[9]  A. Bejan,et al.  Three-dimensional optimization of staggered finned circular and elliptic tubes in forced convection , 2004 .

[10]  Kwang‐Yong Kim,et al.  Multi-objective optimization of a cooling channel with staggered elliptic dimples , 2011 .

[11]  Wei Li,et al.  Heat transfer characteristics of falling film evaporation on horizontal tube arrays , 2011 .

[12]  Shuyan He,et al.  Numerical investigation of the turbulent cross flow and heat transfer in a wall bounded tube bundle , 2014 .

[13]  A. Gomaa,et al.  Thermal performance criteria of elliptic tube bundle in crossflow , 2009 .

[14]  Joel H. Ferziger,et al.  Computational methods for fluid dynamics , 1996 .

[15]  D. Ting,et al.  An experimental characterization of cross-flow cooling of air via an in-line elliptical tube array , 2004 .

[16]  Fang Yuan,et al.  Two energy conservation principles in convective heat transfer optimization , 2011 .

[17]  Nagamany Nirmalakhandan,et al.  Desalination using solar energy: Towards sustainability , 2011 .

[18]  James E. O'Brien,et al.  Local Heat Transfer and Pressure Drop for Finned-Tube Heat Exchangers Using Oval Tubes and Vortex Generators , 2001, Heat Transfer: Volume 1 — Fundamentals of Heat Transfer.

[19]  Xiaoze Du,et al.  Thermal hydraulic performance of a seawater desalination system coupled with a nuclear heating reactor , 2001 .

[20]  Reinhard Radermacher,et al.  Optimization of novel heat exchanger design for the application to low temperature lift heat pump , 2012 .

[21]  Wei Liu,et al.  Numerical studies on heat transfer and friction factor characteristics of a tube fitted with helical screw-tape without core-rod inserts , 2013 .

[22]  K. Bourouni,et al.  Modelling of heat and mass transfer in a horizontal-tube falling-film evaporator for water desalination , 1998 .

[23]  Shichang Wang,et al.  Heat-transfer film coefficients of falling film horizontal tube evaporators* , 2004 .

[24]  Elias K. Stefanakos,et al.  Solar assisted sea water desalination: A review , 2013 .

[25]  Francesco Calise,et al.  A novel solar trigeneration system integrating PVT (photovoltaic/ thermal collectors) and SW (seawater) desalination: Dynamic simulation and economic assessment , 2014 .

[26]  Mohammad Reza Rahimpour,et al.  Simulation and optimization of a six-effect evaporator in a desalination process , 2009 .

[27]  XinGang Liang,et al.  Field synergy optimization and enhanced heat transfer by multi-longitudinal vortexes flow in tube , 2005 .

[28]  Qun Chen,et al.  Field synergy equation for turbulent heat transfer and its application , 2007 .

[29]  W. Vicente,et al.  Large Eddy Simulation of a flow through circular tube bundle , 2010 .

[30]  Bu-Xuan Wang,et al.  A novel concept for convective heat transfer enhancement , 1998 .

[31]  Mark F. Tachie,et al.  Experimental study of turbulent cross-flow in a staggered tube bundle using particle image velocimetry , 2007 .

[32]  V. W. Goldschmidt,et al.  Measurements of the overall heat transfer from combustion gases confined within elliptical tube heat exchangers , 2002 .

[33]  P. Sivakumar,et al.  Forced convection heat transfer from an elliptical cylinder to power-law fluids , 2008 .

[34]  Bo Zhang,et al.  Exergy analysis of a solar-assisted MED desalination experimental unit , 2013 .