Rollable ferroelectric liquid crystal devices monostabilized with molecularly aligned polymer walls and networks

This paper describes a flexible monostabilized ferroelectric liquid crystal (FLC) device using molecularly aligned polymer walls and networks, which are sequentially formed with a two‐step photopolymerization‐induced phase separation. When ultraviolet (UV) light was irradiated through a photomask onto a heated nematic phase solution of FLC and monomer, monomer molecules that had flowed into the irradiated areas were photopolymerized, and polymer walls aligned along the rubbing direction of the polyimide alignment layers on plastic film substrates were formed. After uniform UV irradiation without a photomask, polymer networks aligned along the rubbing direction were formed in the FLC. The FLC molecules were monostabilized in the rubbing direction by the strong anchoring of the polymer networks. The device, which was sandwiched between crossed polarizers, exhibited a monostable electro‐optic characteristic with a high contrast ratio of over 100:1 and a response time of less than 1 ms. The FLC device exhibited spatially uniform operation even when it was rolled up with a radius of curvature of 1.5 cm.

[1]  Taiichiro Kurita,et al.  Reliable Polymer-Stabilized Ferroelectric Liquid Crystal Device Using Thin Plastic Substrates , 2003 .

[2]  Kenji Kawasaki,et al.  Invited Lecture. Ferroelectric liquid crystalline polymers and related model compounds with a low–moderate degree of polymerization , 1993 .

[3]  Hideo Fujikake,et al.  Rigid Formation of Aligned Polymer Fiber Network in Ferroelectric Liquid Crystal , 1999 .

[4]  Andrew G. Glen,et al.  APPL , 2001 .

[5]  Shinichi Nakamura,et al.  Novel Ferroelectric Liquid Crystal Mode for Active Matrix Liquid Crystal Display Using Cholesteric–Chiral Smectic C Phase Transition Material , 1999 .

[6]  Yoshihide Fujisaki,et al.  Organic Thin-Film Transistors on a Plastic Substrate with Anodically Oxidized High-Dielectric-Constant Insulators , 2003 .

[7]  S. Kobayashi,et al.  Fabrication of a Zigzag Defect-Free Surface-Stabilized Ferroelectric Liquid Crystal Display Using Polyimide Orientation Film , 1998 .

[8]  N. Clark,et al.  Submicrosecond bistable electro‐optic switching in liquid crystals , 1980 .

[9]  Hideo Fujikake,et al.  Molecular alignment enhancement phenomenon of polymer formed from a liquid crystal monomer in a liquid crystal solvent , 2003 .

[10]  Tetsuji Ishitani,et al.  Influence of the Surface Alignment Conditions and the Polymer Stabilization on the Electrooptic Characteristics of Ferroelectric Liquid Crystal Displays Exhibiting Half-V Switching : A Comparison of Photoalignment and Rubbing Technique : Structure and Mechanical and Thermal Properties of Condensed M , 2001 .

[11]  Hideo Fujikake,et al.  Flexible Grayscale Ferroelectric Liquid Crystal Device Containing Polymer Walls and Networks , 2002 .

[12]  Yoichi Takanishi,et al.  Thresholdless antiferroelectricity in liquid crystals and its application to displays , 1996 .

[13]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.

[14]  Hiroshi Hasebe,et al.  Mesogenic Polymer Stabilized Ferroelectric Liquid Crystal Display Exhibiting Monostability with High Contrast Ratio and Grayscale Capability. , 1997 .

[15]  Taiichiro Kurita,et al.  Bending Tolerance of Ferroelectric Liquid Crystal with Polymer Walls Fastening Plastic Substrates , 2003 .