A Survey of Active Fault Diagnosis Methods

Abstract During the last three decades, there has been a growing interest in active fault diagnosis (AFD) and several important results have been reported in the literature. This survey aims to provide a compact up-to-date overview of main research directions and to propose a basic classification of AFD methods. The contributions are presented almost in the chronological order as they appeared in the literature and they are divided into two groups that differ in the way the uncertainties are modeled. The survey is concluded with the description of main trends, some application results, and future challenges in the area of AFD.

[1]  F. Kerestecioğlu *,et al.  Optimal input design for the detection of changes towards unknown hypotheses , 2004, Int. J. Syst. Sci..

[2]  R. Nikoukhah,et al.  A mixed I approach to simultaneous fault detection and control , 2004, Autom..

[3]  Jakob Stoustrup,et al.  Active fault diagnosis by controller modification , 2010, Int. J. Syst. Sci..

[4]  Stephen L. Campbell,et al.  Auxiliary signal design for active failure detection in uncertain linear systems with a priori information , 2006, Autom..

[5]  François Delebecque,et al.  Auxiliary signal design for robust multimodel identification , 2002, IEEE Trans. Autom. Control..

[6]  Stephen L. Campbell,et al.  On the Detection of Small Parameter Variations in Linear Uncertain Systems , 2008, Eur. J. Control.

[7]  Stephen L. Campbell,et al.  Optimal piecewise-constant signal design for active fault detection , 2009, Int. J. Control.

[8]  Henrik Niemann.  A model-based approach to fault-tolerant control , 2010, 2010 Conference on Control and Fault-Tolerant Systems (SysTol).

[9]  C.A. Jacobson,et al.  An integrated approach to controls and diagnostics using the four parameter controller , 1991, IEEE Control Systems.

[10]  Miroslav Simandl,et al.  On infinite horizon active fault diagnosis for a class of non-linear non-Gaussian systems , 2014, Int. J. Appl. Math. Comput. Sci..

[11]  Pedro Casau,et al.  A Set-Valued Approach to FDI and FTC of Wind Turbines , 2015, IEEE Transactions on Control Systems Technology.

[12]  Davide Martino Raimondo,et al.  Active fault diagnosis: A multi-parametric approach , 2017, Autom..

[13]  Miroslav Simandl,et al.  Constrained Active Fault Detection and Control , 2015, IEEE Transactions on Automatic Control.

[14]  François Delebecque,et al.  Detection signal design for failure detection: a robust approach , 2000 .

[15]  M. Zarrop,et al.  Input design for detection of abrupt changes in dynamical systems , 1994 .

[16]  Henrik Niemann,et al.  A Setup for Active Fault Diagnosis , 2006, IEEE Transactions on Automatic Control.

[17]  Jakob Stoustrup,et al.  Design of integrated systems for the control and detection of actuator/sensor faults , 1997 .

[18]  Stephen L. Campbell,et al.  A Multi-Model Approach to Failure Detection in Uncertain Sampled-Data Systems , 2005, Eur. J. Control.

[19]  Richard D. Braatz,et al.  Input design for guaranteed fault diagnosis using zonotopes , 2014, Autom..

[20]  Brian C. Williams,et al.  Active Estimation for Jump Markov Linear Systems , 2008, IEEE Transactions on Automatic Control.

[21]  Niels Kjølstad Poulsen,et al.  Active Fault Diagnosis Based on Stochastic Tests , 2008, Int. J. Appl. Math. Comput. Sci..

[22]  Ramine Nikoukhah,et al.  Guaranteed Active Failure Detection and Isolation for Linear Dynamical Systems , 1998, Autom..

[23]  Steven X. Ding,et al.  A Survey of Fault Diagnosis and Fault-Tolerant Techniques—Part II: Fault Diagnosis With Knowledge-Based and Hybrid/Active Approaches , 2015, IEEE Transactions on Industrial Electronics.

[24]  Steven X. Ding,et al.  Integrated design of feedback controllers and fault detectors , 2009, Annu. Rev. Control..

[25]  Stephen L. Campbell,et al.  Effects of feedback on active fault detection , 2012, Autom..

[26]  C. Nett.  Algebraic aspects of linear control system stability , 1985, 1985 24th IEEE Conference on Decision and Control.

[27]  Stephen L. Campbell,et al.  Auxiliary signal design for rapid multi-model identification using optimization , 2002, Autom..

[28]  Franco Blanchini,et al.  Active Fault Isolation: A Duality-Based Approach via Convex Programming , 2017, SIAM J. Control. Optim..

[29]  Richard D. Braatz,et al.  Perspectives on Process Monitoring of Industrial Systems , 2015 .

[30]  Seyedmojtaba Tabatabaeipour.  Active fault detection and isolation of discrete-time linear time-varying systems: a set-membership approach , 2015, Int. J. Syst. Sci..

[31]  Richard D. Braatz,et al.  Closed-loop input design for guaranteed fault diagnosis using set-valued observers , 2016, Autom..

[32]  Stephen L. Campbell,et al.  Auxiliary signal design for robust active fault detection of linear discrete-time systems , 2011, Autom..

[33]  Miroslav Simandl,et al.  Active fault detection and control: Unified formulation and optimal design , 2009, Autom..

[34]  François Delebecque,et al.  Test signal design for failure detection: A linear programming approach , 2003 .

[35]  Stephen L. Campbell,et al.  Active Robust Fault Detection in Closed-Loop Systems: Quadratic Optimization Approach , 2012, IEEE Transactions on Automatic Control.

[36]  Stephen L. Campbell,et al.  An active approach for detection of incipient faults , 2010, Int. J. Syst. Sci..

[37]  Y. Bar-Shalom,et al.  Dual effect, certainty equivalence, and separation in stochastic control , 1974 .